replace xerox toner cartridge/imaging drum

1. Replacing Xerox compatible Imaging unit
Imaging Unit: replace
The kit consists of these items:
Imaging unit
Filter
Blower/brush cleaning tool
Remove the used imaging unit
1. Turn power off when you replace any of the components.
2. Open the front door.
3. To unlock the imaging unit, turn the large blue knob counterclockwise.
4. pull out the imaging unit until it stops.
5. Lift up the blue handle to the left of the i
6. Slide the imaging unit out all the way; cover it completely to prevent damage from exposure to
light, and set it aside.
Clean the sensors
1. Using the blower/brush cleaning tool that was included in the imaging unit
the three sensors inside the printer.
Replace the filter
1. Pull out the used filter and dispose of it as normal office waste.
2. Insert the new filter.
Insert the new imaging unit
1. Unpack the new imaging unit
2. Turn the two small blue knobs clockwise to align the triangles.
3. Remove the tape from the protective plastic sheet; then remove the sheet from the imaging
unit.
4. Insert the new imaging unit into the printer, holding it by the blue handles.
5. Release the left handle and slide the unit in until it stops.
6. Turn the large blue knob clockwise to insert the imaging unit completely and to lock it.
7. When properly installed, the lock icon aligns with the triangle, close the front door.
Reset the copy count
1. Press the Yes button, then the Confirm button to automatically reset the copy count.
Brand names and trademarks are the
Copyright
Replacing Xerox compatible Imaging unit
The kit consists of these items:
the used imaging unit
when you replace any of the components.
To unlock the imaging unit, turn the large blue knob counterclockwise.
pull out the imaging unit until it stops.
Lift up the blue handle to the left of the imaging unit to release the catch.
Slide the imaging unit out all the way; cover it completely to prevent damage from exposure to
Using the blower/brush cleaning tool that was included in the imaging unit
the three sensors inside the printer.
Pull out the used filter and dispose of it as normal office waste.
Turn the two small blue knobs clockwise to align the triangles.
Remove the tape from the protective plastic sheet; then remove the sheet from the imaging
Insert the new imaging unit into the printer, holding it by the blue handles.
handle and slide the unit in until it stops.
Turn the large blue knob clockwise to insert the imaging unit completely and to lock it.
When properly installed, the lock icon aligns with the triangle, close the front door.
button, then the Confirm button to automatically reset the copy count.
the property of their respective holders and are for descriptive
Copyright 1993 - 2016 euccoi . All Rights Reserved.
www.euccoi.com
Replacing Xerox compatible Imaging unit
To unlock the imaging unit, turn the large blue knob counterclockwise.
maging unit to release the catch.
Slide the imaging unit out all the way; cover it completely to prevent damage from exposure to
Using the blower/brush cleaning tool that was included in the imaging unit packaging, clean
Remove the tape from the protective plastic sheet; then remove the sheet from the imaging
Insert the new imaging unit into the printer, holding it by the blue handles.
Turn the large blue knob clockwise to insert the imaging unit completely and to lock it.
When properly installed, the lock icon aligns with the triangle, close the front door.
button, then the Confirm button to automatically reset the copy count.
descriptive purpose only.