The document summarizes the responsibilities of a Product Design Manager in the Engineering Department of GMV. The role involves leading 14 engineers across chassis, trim, and electrical groups; developing and validating new components; and localizing vehicles and technologies for the Andean market. Some key projects mentioned include developing a plastic fuel tank for the Aveo, integrating satellite telematics systems, and adapting vehicles to run on natural gas. The role also requires collaborating with various engineering centers, preparing technical documentation, assisting manufacturing, and ensuring regulatory compliance.

1. Product Design Manager : attached the organization chart ( some names has been changed, but it represents the organization of the Engineering Department at GMV) 1.Lead the Chassis, Trim and Electrical engineering groups: 14 Engineers responsible for engineering change management and vehicle integration strategies for automotive components including Electrical wiring, radios and speakers, alternators, batteries, electronic modules, ChevyStar Telematics components, seat systems, seatbelts, carpet, insulators, brakes, front/rear disk and drum, brake pipes, rear axles, propeller shafts, axle shaft, fuel tank system, fuel lines, electronic control systems/modules, tire and wheel, glasses, windshield, exhaust system, catalytic converters , lubricants and fluids, paint and ELPO system. 2.Lead the engineers within the electrical, mechanical or chemical engineering concepts to release, develop , integrate and validate components following design engineering requirement/standards, the PPAP ( Part Approval Process) development process and Lead Engineering Centers assistance.