1. Helpful Comments for ITICS:
Please do NOT install the software from the location above, it may take forever!
Copy to the local machine, then do the local setup.
Also, do not change the path of default installation, chose what installer
proposes. Do not install unless Java exists.
When HANA client gets installed, it searches for a particular registry key
value, and when not found, it just fails, without any sensible error.
The reason is, the parameter 'SystemDirectory' did not exist at the
HKLMSystemCurrentControlSetControlWindows.
So open the registry editor with regedit, and create a new string with value
%SystemRoot%system32
After this restart the installation, which may fail again, but with a new error
this time. It could not register the MDX provider correctly.
Do manual registration with:
Change directory to: C:WindowsSystem32
Then on command prompt type the below>regsvr32 "C:Program
FilessaphdbclientSAPNewDBMDXProvider.dll
It should give the successful registration message.
When installing SAP GUI, use the below setup file:
Z:03. SAP GUI NW_720PRES1GUIWINDOWSWIN32SetupAll.exe