1. AFFORDABLE AND PROVICIENCY
INVERTER
Portray By
N. Mahira Banu

2. SCOPE
 To design a less expensive and high efficiency inverter
 Adoptable for Economically disadvantage peoples

3. ABSTRACT
 Inverter crude form of an UPS
 Amplifying Section is done with the help of Transistors
 Oscillator is used to invert DC voltage to AC voltage
 Transformer is used to provide high output current

4. FURTHER TECHNOLOGIES
 Inverter using Microcontroller and Solar Panel
 High Cost
 High Maintenance
 Occupying more space
 Required more components

5. PROPOUND TECHNOLOGY
 We proposed Inverter which is in-expensive and high
efficiency.
 IC 4049, Oscillator is used for an Oscillating section
 Applied Oscillating signal is stepped up by using step-
up-transformer
 The battery charger is used to charge the battery when
AC main is restored

6. BLOCK DIAGRAM
I/P
Battery Oscillator Transformer
O/P
Buffer Transistor

7. REQUIREMENTS
 Oscillator-IC4049
 Transistor
 T1&T2- TIP127
 T3&T4-RCA40411
 Buffer
 Battery& Battery Charger
 Transformer

8. IC 4049 Oscillator
 For generating large magnitude of Alternating voltage
from Stored Direct Voltage
 It is a voltage doubler
 It uses less energy

9. Transistor
 Transistor is used as amplifier
 TIP127 is general purpose amplifier & Low speed
switching transistor
 RCA40411 transistor act as an amplifier and switch

10. TRANSFORMER
 A transformer is an electrical device that transfers
energy between two circuits through electro
magnetic induction
 It is used as safe and efficient Voltage converter

11. CIRCUIT DIAGRAM

12. CIRCUIT DESCRIPTION
 N1&N2 is an Oscillator performs the primary function
of supplying square wave
 Gate N3 to N6 act as buffer. Output of buffer is applied
to base of the transistors T1&T2
 Output of T1&T2 is given to the transistor T3&T4.
 It deliver the entire voltage to the transformer and it
stepped up to 230V AC

13. RESULT

14. GAIN
 Low Cost
 High Efficient
 Easy Maintenance
 Occupying less space

15. REFERENCES
• [1]Hazlan bin md. Rosdan,“12v car battery to 230 V AC
power inverter” in 2009 submitted to University Malaysia
Pahang
• [2]Oliver Rich & William Chapman ,“ Three-Level PWM
DC/AC Inverter Using a Microcontroller” in April 2011
conference sponsored by NECAMSID
• [3]DANFOSS Solar inverter concept paper of “TLX
Technology”-MAY 2011

16. LITERATURE REVIEW
• According to paper[1] and paper[2] uses microcontroller, it is
high cost, difficult to assemble, Heavy weight, required more
components
• On the other hand paper [3], the 100’s of inverters are connected
to the main system via the LAN connection In this lot of Cables
are required, High Cost, Occupying more space, It need human
interaction for monitoring the inverters

17. CONCLUTION
 By this method underprivileged can get electricity during
mains off
 Less weight, maintenance free inverter it’s very useful in
villages