Successfully reported this slideshow.

Nec lt 280 lcd projector operating instructions

2,380 views

Published on

How to setup and run NEC LCD projector.

  • Be the first to comment

Nec lt 280 lcd projector operating instructions

  1. 1. NEC LT-280 LCD Projector Operating Instructions
  2. 2. Component Parts
  3. 3. Setup Steps in Order <ul><li>Set up Screen and Projector </li></ul><ul><li>Connect Power cables </li></ul><ul><li>Connect LCD Projector to Computer </li></ul><ul><li>Remove Lens Cap from Projector </li></ul><ul><li>Power On LCD Projector </li></ul><ul><li>Power On Computer </li></ul>
  4. 4. Connect Power Cable Power Cable Plug-in
  5. 5. Connect Projector to Computer (15 Pin LCD Computer Cable) 15 Pin Cable Port Make sure cable in plugged into “Computer 1 In”
  6. 6. Connect Other End of 15 Pin Computer Cable to VGA Port of your computer VGA port may be on side of laptop
  7. 7. Remove Lens Cap
  8. 8. Turn on LCD Projector <ul><li>Projector has two power switches </li></ul><ul><ul><li>A main Power switch (on back bottom right of LCD Projector) </li></ul></ul><ul><ul><li>A Power Standby button (on top of LCD Projector </li></ul></ul>
  9. 9. Turn on Computer Boot Up Computer After You Connect And Turn On Projector
  10. 10. Caution!! <ul><li>Do not unplug projector or turn off main power switch under any of the following circumstances – You could damage the projector </li></ul><ul><ul><li>While projector lamp is lighted </li></ul></ul><ul><ul><li>While the cooling fan is running. The cooling fan will continue to run about 2-3 minutes after the projector is turned off. </li></ul></ul><ul><ul><li>While the PC CARD access indicator lights – doing so can damage your PC memory card. </li></ul></ul>
  11. 11. Caution!!
  12. 12. Adjust Picture Size and Position <ul><li>Place Projector on Flat Surface and make sure it is square to screen </li></ul><ul><li>Lift front end of projector to center vertically </li></ul><ul><li>Rotate Projector to center horizontally </li></ul>
  13. 13. Adjust Tilt Foot <ul><li>Lift front end of projector </li></ul><ul><li>Push up the adjustable tilt foot levers on left and right sides of projector to extend tilt foot </li></ul><ul><li>Lower front of projector to desired height </li></ul><ul><li>Release adjustable tilt lever to lock adjustable tilt foot </li></ul>
  14. 14. Zoom and Focus <ul><li>Use ZOOM Lever to adjust image size on screen </li></ul><ul><li>Use FOCUS ring to obtain best focus </li></ul>
  15. 15. After Presentation
  16. 16. Powering Down <ul><li>Press “On/Standby Button” </li></ul><ul><li>Prompt will appear on screen </li></ul><ul><li>Press “On/Standby Button” again to confirm </li></ul>
  17. 17. Powering Down <ul><li>Do not unplug projector or turn off main power switch after powering down projector while the cooling fan is running. Computer fan must run to cool off projector – You could damage the projector or bulb. </li></ul><ul><ul><li>The cooling fan continues to run 1-2 minutes after the projector is turned off </li></ul></ul>
  18. 18. Powering Down
  19. 19. Replace Lens Cap

×