An employee suffered a hand injury at work in 2015 when their hand was pinched between existing pipework and a valve handle during maintenance. The employee was taken to the site medical center and then to the hospital, where they were diagnosed with a fractured finger and an open cut. The document provides reminders about identifying and communicating potential pinch points during manual tasks, using guards and gloves properly, and taking precautions like marking hazards to prevent similar injuries.
1. Professionalism ▪ Integrity ▪ Trust ▪ Team Spirit
HAND INJURIES – Incident TBT from June 2015
This incident happened in 2015 and is a reminder to all personnel to be aware of potential
pinch points.
During the incident the IP’s hand was pinched in-between the existing pipework
and what is thought to be the valve handle of the old spool. The IP was taken to
the site Medical Centre and then referred to hospital. He was then diagnosed with
a fractured r/h ring finger and open cut.
So, let’s look at how this could be prevented.
When looking at a manual handling task ensure that you plan the path of
travel that the object is going to take. Recognise any potential pinch or trap
points and ensure these are communicated within the work group.
Ensure that you keep communicating between the work team throughout
the operation.
Don’t rely on your gloves as a barrier to a pinch point. Most work gloves
are not impact rated.
If you are removing any pipework that leaves sharp edges or potential pinch
points then mark them accordingly with hazard tape and communicate them
with your work group, this alerts any personnel new to the task that they are
there.
HAND SAFETY
Handling sharp objects - Placing hands in the line of fire - Contact with hot materials
Machine guards have been installed to protect you. When you bypass them
you risk serious injury. Be sure they are in place before you begin your work.
Know what guards should be on your tools, the purpose of them and where they
should be placed.
Toolbox Talk
2. Professionalism ▪ Integrity ▪ Trust ▪ Team Spirit
A handle is positioned for two functions. The first is to allow the ultimate control of the tool
whilst in use. The second is to eliminate the chance of your hand contacting the rotating
part of the machine.
When cleaning machinery or handling swarf from drilling operations, always wear
gloves and use a hand brush to clear swarf.
Always use the correct tool for the job and use it properly. Tools can pose a hazard to your
hands if they’re used improperly. When cutting ensure that the knife is positioned so you cut
away from your hands and body and always wear cut resistant gloves.
Crushing hazards are common at home and at work. Exercise caution when
working with hammers; always use a chisel guard when chiseling and a Finger-
saver when using a flogging spanner.
Gloves are your last line of defence and provided to protect you - establish which
gloves are required for the task and wear them.
Prevention is the best cure Wear the appropriate personal protective equipment. Avoid
direct contact with skin irritants. Wash hands with soap and water before taking breaks, having
lunch, or leaving work. If you get any chemicals or other irritant on your hands, wash them
immediately and report it.
You only have one pair of hands, so look after them!