test123

1. How to make a
network cable

2. Equipment
• 2 RJ45 Connectors
• Unshielded Twisted Pair Cable
• Crimping Tool

4. 1st step
Unroll the required length of network cable and add a little extra wire , just in case

5. 2nd step
Carefully remove the outer jacket of the cable.

6. 3rd step
Inspect the newly revealed wires for any cuts or scrapes that expose the copper
wire inside.

7. 4th step
• Untwist the pairs so they will lay flat between your fingers.

8. 5th step
Arrange the wires based on the wiring specifications you are following.
(cross over system)

9. 6th step
Press all the wires flat and parallel between your thumb and forefinger.

10. 7th step
Keep the wires flat and inoder as you push them into the RJ44 plug with the
flat surface of the plug on top.

11. 8th step
Place the wired plug into the crimping tool and press the handle. Then repeat
all of the above steps with the other end of the cable.

12. 9th step
Test the cable to ensure that it will function in the field.