This document contains instructions for an engineering drawing examination consisting of two parts worth a total of 60 marks. Part A is worth 20 marks and contains 4 short answer questions requiring candidates to complete tasks like printing lettering, redrawing a figure with dimensions, constructing a pentagon, and drawing an auxiliary view. Part B is worth 40 marks and contains 4 longer answer questions, choosing any 4 out of 10, involving tasks like drawing the convolution and development of a helix, projections of a hexagonal plane, different views of an object, sectional views of an object, an isometric view from given views, and the development of a funnel.

1. 046
046
046
046
*
*
*
C14–CE–107/C14–CM–107
4018
BOARD DIPLOMA EXAMINATION, (C–14)
OCT/NOV—2016
DCE—FIRST YEAR EXAMINATION
ENGINEERING DRAWING
Time : 3 hours ] [ Total Marks : 60
PART—A 5×4=20
Instructions : (1) Answer all questions.
(2) Each question carries five marks.
(3) All dimensions are in mm.
(4) Take suitable scale whenever required.
1. Print the following in single-stroke inclined capital lettering of
10 mm size :
‘‘COME TO LEARN AND GO TO SERVE’’
2. Redraw the following figure to full-scale and dimension it by
unidirectional system :
/4018 1 [ Contd...
* 4 0 1 8 *

2. 046
046
046
046
*
*
*
3. Construct a pentagon of 25 mm side by general method.
4. Given below are the views of an object. Draw the auxiliary view in
the direction of arrow :
PART—B 10×4=40
Instructions : (1) Answer any four questions.
(2) Each question carries ten marks.
(3) All dimensions are in mm.
(4) Take suitable scale whenever required.
5. Draw one convolution of cylindrical helix of dia. 50 mm and
pitch 60 mm. Also draw the development of helical curve.
6. A regular hexagon of 30 mm side has its one edge on HP. The
surface of the plane is perpendicular to VP and inclined at 40°
to HP. Draw the projections of the plane.
/4018 2 [ Contd...

3. 046
046
046
046
*
*
*
7. Draw the following views of the object shown in figure below :
Front view — X direction
Left side view — Z direction
Top view — Y direction
8. Draw the sectional front view and top view of the object shown
in figure below :
/4018 3 [ Contd...

4. 046
046
046
046
*
*
*
9. Draw an isometric view of a machine block whose front view
and top views shown in figure below :
10. Draw the development of the funnel shown in figure below :
H H H
/4018 4 AA6(T)—PDF