3. 1st Prototype
From our 1st
prototype we tried to
understand the
pulling capacity of
the motor and
feasibility of using
3d-printed gears
4. 3-D Printed gears could
not handle the stress
Sufficient traction
wasn't available to the
tyres.
Steel Shaft of 4mm was
not durable and bended
significantly
Shortcomings:-
6. PARTS USED:-
For Chassis - We used aluminium Brackets
For Base - 3mm Acrylic sheet
Gears - 3-D Printed Spur Gears (Tough PLA)
Front Wishbone - 6mm Aluminium Rod
(HandCrafted)
Front steering Mechanism- 3D Printed Servo
Mount
Tyres coupling - 3D Printed coupling
1.
2.
3.
4.
5.
6.
12. We have used an ESP 32
to remotely control our
vehicle.
REMOTE
CONTROL
ESP 32 has a WiFi
module thus,
anyone can control
the car with their
mobile phones or
laptops