Task: Turn ON an LED connected to a digital pin when the pushbutton connected to an
analog pin is pressed 5 times and reset the accumulated presses by a reset button, by
connecting the pushbutton to the external pull-down resistor and the reset button to the built-in pull-up resistor.
Abortion Clinic In Stanger ](+27832195400*)[ 🏥 Safe Abortion Pills In Stanger...
Turn on an LED after 5 presses on a push button with a pull down,up resistors
1. Jordan University of Science and Technology
Faculty of Engineering
[Mechanical Engineering Department]
Fall semester 2020/2021
ME464 Control Lab
Experiment ([2]): [Digital inputs]
Student Name: Osaid Qasim
Date: [11/03/2021]
2. Task: Turn ON an LED connected to a digital pin when the pushbutton connected to an
analog pin is pressed 5 times and reset the accumulated presses by a reset button, by
connecting the pushbutton to the external pull-down resistor and the reset button to the built-
in pull-up resistor.
1. Equipment and Materials
1- Arduino Uno development board.
2- Breadboard
3- External LED
5- Tinkercad online software
6- Resistors with 220 Ω connected to LEDs, and resistors with 2.2 kΩ connected to pushbuttons
7- Wires to connect the external LED, push buttons and resistors to the Arduino board.
8- 4 push buttons (one of them as a reset button).
2. Wiring
3. Video for the simulation of the task:
https://drive.google.com/file/d/1AeX3yXC4Y915HFMN3qXV
gX8WeYeo6e6D/view?usp=sharing
LINK OF THEPROJECT ON TINKERCAD
Turn on an LED after 5 preset on a PUSHBUTTON + reset
button | Tinkercad