This is assignment

1. Assignment
problem 1,2,4

2. Engine parts

3. Fuselage Assembly

4. A maker is about to
assemble shuttlecock.

5. Nose Gear Installation

6. Main Gear Installation

7. Combination

8. A maker put a seal.

9. Difficult Point - Engine parts
It is difficult to bond while fixing the propeller of engine.
So first, User should adhere D9 of propeller to D13(or D14). After that, you
adhere to D12(or D15).

10. Difficult Point - Fuselage Assembly
We don’t have glue. So, we
think difficult we put parts on
other parts of all step. Step4
is very difficult in particular.
Step4 have each parts is A
little heavily and size. So, It
couldn't be put easily.
Tab for sticking

11. Difficult Point-Main Gear
Main Gear is the important parts to support an Airplane! Because it was
reproduced to the detail, a part was small, and assembly was very difficult.

12. One of difficult point
Look at this photo. Do you see parts? These parts is very small. A maker who
must cut these parts from kit. It is difficult for a maker to cut parts without
scissors.

13. 3 key points
-Sharing of roles
This Assignment is the problem of doing by a group, so allotment of roles is
necessary to make without waste quickly. When making a model, sync was
important (Parts are separate, put together,etc). As far as it was possible, I also
had to make up with the next step.
-Adjust the schedule
This Assignment is too difficult to bring to an end during class. Therefore they
had to gather time outside the tuition to bring this question to an end. So it
became important to behave together with a schedule.
-Understand about Assignment
When it wasn't understood and was begun, I didn't know what I could do
because there was a lot of delicate work. So it was necessary to understand a
group Assignment of all the members.