1. JAPAN AIRLINES
BOEING 767-300ER
Assembly method
You need prepare adhesive and nippers for
assembly. You need prepare water and dry
towel for stick seal. If you want to paint, you
need paints.
2. Step 1 Engine Assembly
D9
D10
D12
D13
D9
D15
D14
D11
Left EngineRight Engine
You cut D9~D15 parts. D9, D10, D12 and D13 is right
engine parts. D9, D11, D14 and D15 is left engine
parts. You assemble those parts with the use of
adhesive.
Step 2 Fuselage Assembly
C5
B1
BALLAST
PARTS
A1
A weight is put on the front to put gravity at the front.
A weight is that C5 is insert screw BALLAST PARTS.
This step is big parts of all step. But, The place where
glue is put is small.
3. Step 3 Main Gear
Installation
This Step is made very small parts. D3(D4) will be
put on other parts. C7(C6) is D3(D4)’s outside and
D5(D6) is D3(D4)’s inside. When glue isn't put
tightly, it comes off. So, It is need to put glue
tightly.
D5
D7
C7
D7
D3 D4
C6
D6
Step 4 Nose Gear
Installation
First, you will cut C8 and D8.
Because a part is small,
please be careful.
Next, attach 2 of D8(tire) to C8.
D8
C8
4. Step 5 How to make shuttlecock
First, you cuts parts C1, C2, D1 and D2.
And then C1 and D2 join, C2 and D1 join.
Second, you cuts parts C3 and C4.
D2
C2
C1
C3 C4
D1
Fourth, paste a pasteboard to
plane with wet fingers
Finally, take off a pasteboard
leaves a sticker on the plane
Step 6 How to put stickers
First, cut each a sticker with
pasteboard which you want to
use.
Second, float a pasteboard on
the water for about 20 second
Third, place a pasteboard on a
5. Step 7 Combination
Please Make them combine parts of the former step and C3,C4(Horizonal
Stabilizer Installation) with the Fuselage.
Engine Main Gear
C3
C4
Wing
Nose Gear