2. To begin, I began by firstly programming a sound that
played once the arrow object is created. When this object
is created in-game, it means that an archer has fired it, so I
needed a sound to convey that and arrow had been
shot. I went to the ‘create’ tab as the sound needed to be
played as soon as the arrow was implemented or created,
added a sound option, selected the right sound and
made sure it did not loop.
3. This sound is to be played as soon as the game starts and
is the games back ground music. I did the same as before,
but I added the sound on a ‘create’ tab on my player as
the sound should stop and start when he is currently alive
in-game. I needed this to loop too, so I made sure this
option was set to true.
4. Programming this sound was quite different. I had to
actually script it into the game. The sound plays when an
enemy is defeated, and this is would be very complicated
to do following previous methods so I made sure that the
game would check if an enemy was deceased in a script
before playing this sound. I used the ‘audio_play_sound()’
code.
5. This sound is to be played whenever the
character jumps, so I coded it so that when
the character jumps and is in the air, this
sound will play.
6. Here, when the character shoots his flames, I would like
two sounds to play. There is a flame noise and a triple hit
noise, as when he attacks, he shoots 3 fire balls one after
another. I added a sound action into the ‘Press C-key’ tab
as this was the attack button. When C is pressed, both
sounds will play and they will not loop.
