The document provides information about an exam for a wood processing safety course. It outlines the exam format, including long answer and short answer questions. It provides tips for the exam such as focusing answers on legislation, risk assessment, specific machinery, and processing procedures. It also discusses exam techniques like using bullet points, notes, sketches and color. Sample exam papers from previous years are presented and there is an opportunity for discussion about the course topics.

1. WT4603
Wood Processing Safety &
Practice
Autumn Semester 2011
Lecture Unit 8 (Week 12)
 Final Lecture: WT4603 Exam Preparation
 Notes Prepared by: Mr. Joseph Lyster
 Date: 21-11-2011

2. WT4603
Exam Format:
Department of Design and Manufacturing Technology

3. WT4603
Question Tips
Section A: Long Questions (Answer 2 Questions) (* = Compulsory)
-Promoting Safety
1 (Teachers)* -Legislation
-Risk Magnitude/Assessment
-Duties of Employer/ Employee(s)
2 (Wood Science)* -Legislation
-Risk Magnitude/Assessment
Exam Tips 3
-Rip Saws/ Surface Planers
-Calculations
4 -Wood Processing Procedures/Practices
Section B: Short Questions (Answer Any 10 Questions)
-Machines: Thicknesser, Router (Router
Bits), Rip Saw, and Surface Planer
-Processing
1-15 -Start/Stop Mechanisms
-Legislation
-Wood Dust
-Mechanical Hazards
Department of Design and Manufacturing Technology

4. WT4603
Exam Techniques:
• Question Types
• Marking Scheme
• Response types – Bullet points
• Notes
• Sketches + Annotations
• Colour
• Rough work
2009/10 Paper
Department of Design and Manufacturing Technology

5. WT4603
Department of Design and Manufacturing Technology

6. WT4603
2010/11 Paper
Department of Design and Manufacturing Technology

7. WT4603
DISCUSSION
Topics:
- Lectures
- Labs
- Assignments
- Project Work
- General Feedback
Department of Design and Manufacturing Technology

8. WT4603
Department of Design and Manufacturing Technology