This weekly report summarizes the student's work studying different types of electric pots. The student identified 4 main types: 1) a pot that uses water to transmit heat, 2) a non-automatic electric pot with a heating coil, 3) an automatic electric pot that turns the heater on and off using a contact, and 4) an air pressure automatic pot that pushes water out using air pressure. For next week, the student plans to further study principles and circuits within pots.

1. [INC 281 MULTIDISCIPLINARY WORKSHOP WEEKLY REPORT] January 20, 2012
Name-Surname RawiwanDewihok
Student ID. 53211825
Group Name Fueng
Engineering Team
Arm , Por , Fam , Sanook , Kwang , Will
Members
Product Design
P’Mhor, P’Pum , P’Mint , P’Pin, P’Best
Team Members
Weekly Progress
This week I was assigned by P’Pin to find and study principle ofelectric equipment. I
choose to study about pots. It has 4 types. 1) A Pot use water to be transmitter it has
heating equipment that made from aluminum. 2) Non-Automatic Electric Pots. This pot has
important part to make water hot it is heater. Heater is hot immediately when current flow
into the heating coil. 3) Automatic Electric Pots. When electric current flow through contact it
will make main heater hot and transfer heater to water. While main heater is working lamp
operating condition will show that main heater is transfer heater to water. 4) Air Pressure
Automatic Electric Pots work like Automatic electric pots. However, unlikely when user take
water out of a pot. The user will press the lid on the pot then hot water will flow out of the air
pressure in the pot that is more effective to push the water out.
Figure 1. type of pots
Engineering Analysis
Strong Point
- The pot is a basic electric equipment that everyone know it good.
Weak Point
- Function for use is too less.
Next Week Job
- I will study more principle and circuit in a pot.
Department of Control System and Instrumentation Engineering
KING MONGKUT’s UNIVERSITY OF TECHNOLOGY THONBURI