This report summarizes an experiment on static routing between two routers. The experiment used two PCs, two routers, and crossover cables to create a topology in Cisco Packet Tracer. IP addresses were configured on the PCs and routers using CLI. Static routing was implemented successfully between the routers to define a fixed path. Static routing provides a backup when dynamic routes fail and can transfer routing information between protocols.

1. Department of Computer Science & Engineering
Course Title: Computer Networking Lab
Course Code: CSE-314
Report On: Static route between two routers.
Report No- 3
Submitted to:
Muhammad Taifur Rahman
Lecturer Daffodil International University
Submitted by:
M M Rayhan Parvez
ID: 143-15-4617
Section: F
Submission Date: 14-10-2016

2. Name of The Experiment: Static route between two routers.
Tools:
 Two Pc
 Copper Cross-Over Cable
 Cisco Packet Tracer Software
 Two Routers
Topology:
Implementation:
First I Took Two PC & Two Routers and Connected Them Using Copper Cross-Over Cable.
Then I Configure IP in Both PC & Routers using CLI (Command Line Interface).
Result:
Conclusion:
Static routing can be used to define an exit point from a router when no other routes are available
or necessary. Static routing is often used as a complement to dynamic routing to provide a
failsafe backup in the event that a dynamic route is unavailable. Static routing is often used to
help transfer routing information from one routing protocol to another (routing redistribution).

3. Video Link:
https://www.youtube.com/playlist?list=PLYQHz6JzI70YpGJdyzEo
KnoloU9MH7ztJ