Jee Yeon Park made four feet out of wood to place under a base. They measured and marked four circles using a compass and pencil. They cut the circles out with a jigsaw, then sanded them and drilled holes for screws. Screws were used to attach the feet to the base. Making the feet ahead of schedule allowed more time for painting. The process required balancing time and managing tasks, relating to human ingenuity.

1. Design Technology Process Journal
Date: March, 11st, 2011
Name: Jee Yeon Park
Title: Making four feet
What did I do?
When I got into the workshop, I got a piece of wood to
make four feet to put it under my base. At first, I began
to measure and mark out four feet by using compass
and a pencil. I measured the radius by 1.5 cm and started to make four round circles. When I was done
with measuring and marking the feet, I took out the
Picture 1: Picture of me using jigsaw to
jigsaw to cut the circles. By clamping with the clamp,
cut the circles
the wood didn't mover so it was easy for me to cut them
with the jigsaw. However, since all of the circles were
so small, I just had to cut them into squares. When four
feet were cut by the jigsaw, I used the sand disk to
sand out the part that I didn't need. It took quite a long
time for me to finish sanding the feet. After that, I chose
a proper drill bit to drill on the feet. Due to the fact that
the feet were small, I had to use pedestal drill to drill the
holes. I also drilled on the base by using thinner drill bit
using the cordless drill. Then, I chose the proper size of the screws to screw the feet on the base. By
using the screwdriver, I was able to put the screws through the hole that I have drilled on the feet.
Changes in the gantt chart
I could see some changes in the gantt chart. I was Picture 2: Picture of me using pedestal
going ahead of the timeline that I have predicted. drill to drill the hole on the foot
During
this time,
I should
be putting
parts
together.
However,

2. I am at the stage of finishing putting the parts together. I was able to see a great change in my gantt
chart.
Picture 3: Picture of me using4: Picture of me using
Picture cordless
drill to drill hole on the base
screwdriver to screw the screw into the
hole
Emotions
During this lesson, I was very happy that I am done with putting all of the parts together. Now, I can
begin the stage of painting, which I have been waiting for so long time.
Learner Profile & AOI
In this lesson, I think I was well balanced. This is because I could balance and manage the time well. I
used the double period finish making the four feet that were needed so that the base could stand a bit
higher. Besides, I think this was related to human ingenuity because I was continuing to create parts for
my project.