100kv,1000kv,1000kv technologies,1000kv projects,technologies,live projects,Hyderabad live projects,live projects in, diploma low cost projects,1000kv projects, , academic projects,btech live projects,Hyderabad,1000kilovolts,1000kilovolts technologies ,btech main projects , pure mechanical projects,btech mechanical projects, ,engineering mechanical projects,mechanical kit projects diploma mechanical projects, live projects mechanical,new mechanical projects, electronics projects, electronics projects for engineering final year students, electronics and communication engineering projects for final year students, Mini projects, electrical engineering mini projects abstracts

1. 1000KV TECHNOLOGIES 9030 844 866 / 9030 844 877
ECE / EEE / EIE / MECHAICAL / MECHATRANIC MAIN & MINI PROJECTS
1000KV TECHNOLOGIES
FLAT NO:#A2 ; EurekaCourt Complex ;OPPLine of R.S Brothers; near Image Hosp; Ameerpet
9030 844 866 / 9030 844 877
Knee power generation
Aim:
The main aim of the project is to develop Knee power generator .
Abstract:
Charging circuit :In this project we are using charging circuit to avoid reverse charge protection
because the energy from solar panel is stored into battery .The current from the battery may go to
solar panel in reverse direction to avoid this we are using charging circuit
Dynamo : In this power generation project we are using dynamo for the power generation which
converts kinetical energy into mechanical energy . The shaft spins and is connected to a
generator which creates electricity. By suing sensor here the turbine moves according to the flow
of wind . knee power converts the kinetic energy in to generate electricity or mechanical power.
The Dynamo consists of 3 major components: the stator, the armature, and the commutator.
The stator is a fixed structure that makes magnetic field, you can do this in a small dynamo using
a permanent magnet. Large dynamos require an electromagnet.
The armature is made of coiled copper windings which rotate inside the magnetic field made by
the stator. When the windings move, they cut through the lines of magnetic field. This creates
pulses of electric power.
The commutator is needed to produce direct current. In direct current power flows in only
one direction through a wire, the problem is that the rotating armature in a dynamo reverses
current each half turn, so the commutator is a rotary switch that disconnects the power during the
reversed current part of the cycle
Block Diagram will consist the following modules
 Dynamo
 Charging circuit
 Battery

2. 1000KV TECHNOLOGIES 9030 844 866 / 9030 844 877
ECE / EEE / EIE / MECHAICAL / MECHATRANIC MAIN & MINI PROJECTS
1000KV TECHNOLOGIES
FLAT NO:#A2 ; EurekaCourt Complex ;OPPLine of R.S Brothers; near Image Hosp; Ameerpet
9030 844 866 / 9030 844 877
Block diagram :
Project covering topic
 Dynamo
 Charging circuit
 Battery
uses ;
 easy to implement
 easy to handle

3. 1000KV TECHNOLOGIES 9030 844 866 / 9030 844 877
ECE / EEE / EIE / MECHAICAL / MECHATRANIC MAIN & MINI PROJECTS
1000KV TECHNOLOGIES
FLAT NO:#A2 ; EurekaCourt Complex ;OPPLine of R.S Brothers; near Image Hosp; Ameerpet
9030 844 866 / 9030 844 877
Student Support:
 Working KIT / Project
 Documentation
 PPT
Easy to use, Self-explanatory kit.
All - inclusive solution kit.
Extensive audio-visuals available.
Branding output
Call/mail for Tech Support from 10 am - 7 pm.