To tile a floor or wall: 1. Prepare a smooth surface by removing old tiles and filling any holes. 2. Affix horizontal and vertical batons as guides for tile placement. 3. Apply tile adhesive and carefully affix tiles using spacers for consistency. Cut tiles as needed.

1. How to tile a floor or a wall
Brought to you by HSS Hire

2. Start off with a smooth surface, which makes applying tiles much easier. This can achieve by first using
a tile remover to quickly strip old tiles away. For any holes that remain in the wall, fill over, allow to dry,
and run over with a drywall sanding kit to leave a smooth finish.
You will want to ensure you start placing tiles correctly, so affix two batons to the wall to help guide your
tile placement. Fix one baton horizontally, with the other being placed vertically to give an easy guide to
work with.
Apply your tile adhesive to the ready-prepared surface and carefully affix your chosen tiles. Use spacers
to ensure a consistent placement of tiles across the wall. For over sized tiles, use a HSS manual tile cutter
to get the desired size and shape.
Once tiled, leave adequate drying time for the adhesive to set. At least 24 hours is recommended for most
tile adhesives, but you should always read the instructions as some adhesives may require longer.
Once the adhesive has dried, remove the baton guides and tile right up to the edge of the desired surface.
Allow to dry and then grout the tiles, smoothing off any excess grout with a damp cloth.
Step 1
Step 2
Step 3
Tiling a wall
Step 4
Step 5

3. Ensure a clean working surface for tiling – see tip number one above for details. Use the HSS
Grout Remover to remove any old or unwanted tiles. Consider using our concrete planer tool to
remove any unwanted adhesive residue and create a flat working surface.
Start tiling at the centre of the room – this can be found by creating a line with string from
one corner of the room to opposite corner. When completed from the next corner, the string
will meet in the middle of the room. You should begin tiling from this point.
Ensuring your floor is level and smooth, begin applying tile adhesive to the floor according
to the manufacturer’s instructions. Place tiles on the floor, using a spirit level if necessary
to ensure they are level.
Allow adequate drying time for the tiles, and avoid walking over any of them whilst drying.
Once dry, grout the tiles and leave to dry according to the manufacturer’s instructions.
Before the grout has dried, be sure to wipe off any excess from the tiles with a damp cloth or
sponge
Step 1
Step 2
Step 3
Tiling a floor
Step 4