Hcqs | replacing iphone 6 plus vibrator guide

1. HCQS | Replacing iPhone 6 Plus
Vibrator Guide
Difficulty: Moderate
Relevant Parts: iPhone 6 Plus Vibrator

2. Remove the two 3.6 mm Pentalobe screws next to the
Lightning connector.

3. Hold onto your iPhone securely and close the handle of
the iSclack to separate the suction cups, pulling the front
panel up from the rear case.Peel the two suction cups
off your iPhone.

4. Pull the home button end of the front panel assembly
away from the rear case, using the top of the phone as a
hinge.

5. Several clips along the top edge of the front panel form a
partial hinge, allowing the front panel assembly to swing
open like a book.

6. While holding the front panel open at about a 90º angle,
remove the following screws securing the front panel
assembly cable bracket

7. Remove the front panel assembly cable bracket from the
logic board.

8. While still supporting the front panel, use a plastic
opening tool to disconnect the front-facing camera and
earpiece speaker cable connector.

9. Use a plastic opening tool to disconnect the home
button cable connector.

10. Use a plastic opening tool to disconnect the display data
cable connector.

11. Finally, use a plastic opening tool to disconnect the
digitizer cable connector.

12. Remove the front panel assembly from the rear case.

13. Battery Connector
Remove the following screws from the battery connector
bracket

14. Remove the metal battery connector bracket from the
iPhone.

15. Use a plastic opening tool to gently pry the battery
connector up from its socket on the logic board.

16. Vibrator
Pry the vibrator connector cable up from its socket on
the logic board with the flat end of a spudger.

17. Use the tip of a spudger to disconnect the interconnect
antenna cable from its socket on the logic board.

18. Grasp the interconnect antenna cable with a pair of
tweezers and carefully de-route it from its channel on
the vibrator assembly.

19. Remove the two 2.5 mm Phillips screws securing the
vibrator to the rear case.

20. Remove the vibrator from the iPhone.

21. To reassemble your device, follow these instructions in reverse order.