The EIA/TIA-568-A Common for Cat5 data cabling defines the limitations, both throughout rates and cabling measurement. Newer cable, such as Category 6, is capable of doing much higher speeds, but it surely also costs more as compared to Cat5.

1. https://www.tsmarttechnology.co.uk
Advantages and Disadvantages of Cat5 Data
The EIA/TIA-568-A Common for Cat5 data cabling defines the limitations, both
throughout rates and cabling measurement. Newer cable, such as Category 6, is
capable of doing much higher speeds, but it surely also costs more as compared to
Cat5. When it was introduced in 1995, the type that defined Cat5 data cabling, identified
the upper limits of what four sets of copper wire could conduct for data networking.
Cable development ensures that your network will attempt to work after the cable is fully
installed and ended.
Cat5 Data Cabling Specifications
The Cat5 cabling common set forth performance metrics for Category 5 and Improved
5. The previous, Category 3, set the highest cable speed as 16 Mhz. Cat5 data cabling,
however, is capable of doing speeds up to 100 Mhz. It was known as the 100-Base-T
Network Standard, as opposed to the previous 10-Base-T. The maximum length
enabled for the permanent link, defined because the maximum distance allowable,
which includes patch cords, between active tools on the network, must be no greater
than 90 metres. The Cat5 standard also put testing standards for maximum accessible
levels of attenuation, near- and far-end crosstalk ( NEXT and even FEXT ), and delay
and hinder skew, and a number of further measurements based mostly on crosstalk.
Types of Tests
There are two primary types of tests that could be performed on data cabling,
wiremapping and standards-based tests. The wiremap shows whether the cable is
appropriately terminated at both ends as long as each colour being ended in the proper
location. Standards-based testing additional breaks down into simple validation that the
cable meets the minimum requirements of the Cat5 certification. When it's approved,
the person performing the test simply compares the readings acquired against the
standard. When the cable plant is authorized, the end-user will receive a report
supplying the measurements obtained for every one cable and where that cable goes.
The cable testing tests for compliance of all of the cable metrics specified by the normal
being tested to.
There Are Modern, More Expensive Options
The Cat5 data cabling standard is pretty used. This type of cabling can cause running
100 Megabit Ethernet. The existing standard in data cabling is Cat6 Augmented, which
can be capable of speeds up to 10 Gigabits Ethernet. If you have large amounts of data
that frequently get sent around your system, Cat 6 might be the thing you need.
However, if the amount of real information being sent over your system is quite a bit
lesser, and will remain so for the planned future, Cat5 data cabling will save you a good
deal of cash in material costs. Cat5 data terminations are less difficult to make properly
than Cat6 terminations, equally. Because Cat6 cabling is efficient at such high speeds,
the specifications for proper termination are even more stringent, requiring specialized
training, whilst Cat5 terminations are relatively easy to make appropriately.