3D typical installation drawing from Schiedel. This 3D drawing forms part of our flue and chimney range and can be used with acknowledgement to Schiedel Chimney Systems Ltd. as well as a link to the original source at www.schiedel.com/uk A typical flue installation includes steel chimney pipe or mineral pipe or module components from the heat source appliance (a stove, biomass or gas appliance for example) to its termination point above the roof. Support is required for internal and external chimney systems. Schiedel specialise in wood burning appliances and flues, which are a renewable way of avoiding constant gas or electricity usage when looking at a secondary heat source. Even heat pumps are problematic with severe temperature drops, so a secondary source is always needed.

1. ICID PLUS
INTERNAL CHIMNEY SYSTEM
Universal EPDM rubber/aluminium
diameter tab on the rubber seal
The most frequently used
bends are:
30 Bend
Adjustable Pipe
Adjustable 50mm - 230mm
Adaptor
(Prima Smooth to ICID)
Appliance Connector Increasing Adaptor
Prima Smooth,
Prima Plus or
vitreous enamel
SW-DW Adjustable
Starter Section
Locking Band
45 Bend
L1
L2
Pipe
L1(mm)
1500
1000
500
300
200
L2(mm)
1460
960
460
293
160
CHIMNEY
WITHIN
THE HOUSE
RectangularVentilated Firestop Plate
2 piece
Ventilated Support Plate
2 piece
RoundVentilated Firestop Plate
1 piece
Finish Options:
Plain Galvanised Steel
Black RAL 9005 (Matt)
White RAL 9016 (Matt)
OPTIONAL
Magnetic Firestop Cover
Finish Options:
Plain Galvanised Steel
Black RAL 9005 (Matt)
White RAL 9016 (Matt)
Ventilated
Firestop Plates
Raincap
with sparkguard
Also available
TaperedTerminal
Roof Support
Raincap
without mesh
Air
Shaft
Air
Visit www.schiedel.com/uk for more information Part of BMI GROUP

2. ICID PLUS
EXTERNAL CHIMNEY SYSTEM
Part of BMI GROUP
TaperTerminal
Structural Wall Band
Structural Wall Band
Structural Wall Band Extension
45 Bend
AdjustableTop Plate
Cantilever Support
135 Tee
Mitred Wall Sleeve 45
Visit www.schiedel.com/uk for more information Part of BMI GROUP