Solved Epson Error Code 031008, Install and Setup is made easier in All your printer. To resolve problems and Queries Contact our tech team with Toll-free: 1-800-806-4515.

1. Mangai
Solved: Epson Error Code 031008
Epson error code 031008 displays on the printer’s control panel. It
mainly occurs due to the improper installation of printhead or ink
cartridges into their slots. Dust or debris on any of the above-mentioned
componentsmay lead to this issue.
Quick Steps To Resolve The Epson Error Code
031008
 Reboot the printer and the system.
 Clean and reset the ink cartridge of the printer.
 Uninstall and reinstall the printhead into the Epson printer.
 Check if the cartridge used is compatible with the printer model.
 Use a clean cloth to take the dustoff on the ink cartridge.
 Do not leave the cartridge open for more than 30 minutes.
 Check if the cartridge is installed properly into the printer.
 Try to printfrom the printer to verify if the issue is resolved.
Brief Solutions To Resolve The Epson Error Code 031008
 The error code 031008 can create a pause in the printing session.
The main solution to resolve the issue is rebooting the printer.
Unplug the power cable from the power outlet. Long-press the
Power button for at least 60 seconds.
 After a while, replug the power cable. Release the button after
printer turns on. Try to print a network configuration page from the
printer. If the issue persists, reset the printer to default settings with

2. Mangai
the help of the printer’scontrol panel.
 Long-press the Resume button for 10 to 20 seconds to reset the
printer to default settings in the printer’s control panel. Tap OK and
release the key.
 Try to get a test page from the printer. If the issue is unresolved, the
cause can be dueto the printhead or ink cartridges.
 Use the Power button to turn on the printer. Detach all power cables
connected to the printer. Raise the cartridge cover and take the ink
cartridge out of its slots. Use a clean cloth to wipe the dust or debris
on the cartridge.
 Reinstall the ink cartridges into their slots. Touch the Reset button
against the chip contacts on the cartridge after a while. A stable red
light blinks on the printer’s control panel indicating a strong
communication between the printer and the system.
 Long-press the Reset button for a few minutes until the green LED
light starts blinking.
 You can clean the printhead using an automatic or manual process.
Use the steps mentioned below to start the manualcleaning process.
 Uninstall the printhead by raising the latch. After a while, clean its
contacts and reinstall it.
 Try to print from the printer to check if the error code does not
display on the printer’scontrol panel.