Design

1. ME 2171 : Machine Drawing and
Solid Modelling
Suraj Kumar Behera,
Department of mechanical Engineering,
NIT Rourkela
Contact Details:
Mail id : beherask@nitrkl.ac.in
Mobile: +91-9040893760
Assembly of Solid Models

2. 2
Sample Questions on SolidWorks(Drafting Competencies)
Q1. The drawing view shown is an example of which
SolidWorks view type?
a) Horizontal Brake
b) Aligned section
c) Broken-out section
d) Detail

3. 3
Q2. The drawing view shown is an example of which
SolidWorks view type?
a. Aligned Section
b. Detail
c. Broken-out Section
d. Section
Sample Questions on SolidWorks(Drafting Competencies)

4. 4
Q3. The drawing view shown is an example of which
SolidWorks view type?
a. Aligned Section
b. Detail
c. Broken-out Section
d. Section
Sample Questions on SolidWorks(Drafting Competencies)

5. 5
Fundamental Questions on SolidWorks(Drafting Competencies)
Q1. The Sketches Tab in SolidWorks has all of the following
tools except which one?
a. Line
b. Extrude
c. Smart Dimension
d. Circular Pattern
e. Text
Q2. Where do names and company information go on a
SolidWorks drawing?
a. Title Block
b. On the Object
c. You do not want to leave any information about the designer
in a drawing
d. In every corner of the paper
e. On the back side of the drawing

6. 6
Fundamental Questions on SolidWorks(Drafting Competencies)
Q3. In an Assembly what tool in SolidWorks should be used to
create connections between different parts?
a. Relations
b. Mates
c. Glues
d. Connections
e. None of the Above
Q4. To begin a sketch in SolidWorks the first thing you must
do is?
a. Dimension the lines
b. Lay out a faint line before darkening in it in.
c. Create a set of points that the lines will go through
d. Select the plane that you will draw on.
e. None of the Above

7. 7
Fundamental Questions on SolidWorks(Drafting Competencies)
Q5. The Features Tab in SolidWorks includes all of the
following except what?
a. Revolved
b. Extruded
c. Trim Entities
d. Swept
e. Linear Pattern
Q6. If a feature tool in SolidWorks is not working what is the
most likely issue?
a. There is an error in the sketch
b. The sketch is not fully defined
c. The sketch is not labeled properly
d. The process is going to cause the software to think to much
e. The program just wants to frustrate you (this is not the right
answer)

8. 8
Assignment 3( Knuckle Joint)
D = 100* (1.last two digit of your roll no)

9. 9
Task for Today's Class
i. The value of D= 100*1.(last two digit of your roll no)
ii. Draw the all solid models in SolidWorks in
assignment 3
iii. Assemble them in SolidWorks
iv. Explode the Animation
v. Use the solid model for 2D drawing of all the parts
and assembly.
vi. Each 2D drawing should contain Front Sectional
View , Top view, Side View and isometric view
vii.The Assembly 2D drawing should have bill of
materials

10. 10
Class Performance
Evaluation of all Models for Assignment 3 for
each student.

11. Thank You
11