4. PVCJADQVA=
1.Place the head of the T-square against the edge of the drafting table. (Left side of the
table if you are right handed and at the right side of the table if you are left handed).
2.Slide the working head of the T-square against the working edge of the drawing
table. The two edges should be in constant contact until the desired position.
Ecta= Oc ect usa tna T-squ`ra c e ` e ueavae cr rcubn surg
` j as ` e o eavar jut p`par
` kce b its wcrdieb aoba.
Ecta= Oc ect usa tna T-squ`ra c e ` e ueavae cr rcubn surg
` j as ` e o eavar jut p`par ` kce b its wcrdieb aoba.
9. PROJEDURE=
1. Press firmly the T-square against the working edge of the drawing table.
2. Place the drawing paper close to the working edge of the drawing table and working
head of the T-square depending on you if you are right or left-handed, while the paper is
placed on top edge of the T-square.
3.Fasten the upper left portion of the drawing paper followed by the lower right portion
and finally the remaining corners.
13. PROCEDURE:
1. Press the head of the T-square against the working edge of the drawing table
and lean the pencil to the desired direction of the line inclined at more or less
60 degrees with the drawing table.
2.Maintain the position of the pencil while you glide lightly on the blade of the
T- square.
3.Draw the line from left to right rotating occasionally to produce uniform line
weights.
18. PROCEDURE=
1. Use 45 degrees triangle or 30 degrees x 60 degrees to draw vertical lines.
2. Place the triangle on top of the blade of the T-square with the
vertical edge on the left.
3. With the left hand pressing the T-square and the triangle against the
drawing board, draw the line upward, rotating the pencil slowly between
the thumb and forefinger.