Edit: would love to get the original PDFs of these files so that we can have them edited to RECON for branding consistency
DWS designs, manufactures and provides stick-slip mitigation tools
Use the data to:
Validate their new designs when performing field testing and assure the changes are providing value before implementation
compare the set-up parameters of their stick-slip mitigation tool between runs and customers
Creates reports for the clients based on the data to show that their tools are providing value to their clients
Data has become a standard of their sales offering
Data delivery to clients – value add to their internal processes.
Surprise – suspected damage was off bottom due to connection practice, but damage was happening during drilling.
Overall objective – being able to use data to fine tune connection practices and determine areas where parameters need to change for formation or section of well.
Pad well, and varying degrees of INCL, this really influences vibration modes and severity – determining roadmaps specific to well trajectory is a target for continuous improvement. Need data to determine the parameters for each scenario. Vert well – no contact forces – SS is dominant with 1st harmonic. More contact points at higher incl – means higher harmonic, based on the
Reduce and increase RPM, vs the opposite for whirl.
Flow rate savings – typical use same flow rate for run – flow rate optimisation to ensure that pump off. Equivalent Circulating Density (ECD)
Soft speed control integration – verify the results to get more data and validate the soft torque system and for continuous improvement. Data case be used for client acceptance.