The basic aim is to find out the water content required to produce a cement paste of standard consistency as specified by the IS: 4031 (Part 4) – 1988. The principle is that standard consistency of cement is that consistency at which the Vicat plunger penetrates to a point 5-7mm from the bottom of Vicat mould.

1. WELCOME

2. UNDER THE GUIDANCE OF
Mr. HARISH.B.A B.E., M.Tech.
Assistant Professor
Department of Civil Engineering

3. Basic Material Testing
Lab

4. AIM
APPRATUS
PROCEDURE
RESULT

5. NORMAL
CONSISTENCY

6. AIM
To Determine the normal
consistency of the given cement paste

7. appratus
 The Vicat appratus
 Ordinary portland cement
 Weighing balance
 Measuring cyclinder

8. PROCEDURE
 Take about 500grms of cement.
 Add weighed quantity of water {say about 25% by
weight of cement} for the first trial and prepare a
paste in a standard manner.
 Fill the paste into vicat mould with in 3 to 5
minutes
 Shake the mould to expel air and level the top
surface of the paste

9.  A Standard plunger 10mm diameter and 50mm
length is attached and brought down to touch the
surface of the paste and quickly released allowing
it to sink into the paste by its own weight.
 By taking reading by noting the depth of
pentraction of the plunzer.
 Conduct a second trial by adding water of 27%
by weight of cement and findout the depth of
penteraction of plunzer.

10.  Similarly conduct trials with higher percentages of
water till such time the plunzer penatrates for a
depth of 33 to 35mmfrom top of mould
 That perticular percentage of water which allows
the plenzer to penatrate only to a depth of 33 to
35mm from top of mould is know as the
percentage of water required to produce a cement
paste of standard consistency . This percentage is
usually denoted as ‘P’

11. RESULT
 The standard consistency of the given cement
sample is ________

12. CHETHAN KUMAR R
(569CE15009)
H J MATHAD
(569CE15013)
GANESH K V
(569CE15011)
PRESENTED BY

13. Thank You