1. Salvo Electro-Optics
Salvo EO produces and procures precision optics from the UV to the
FAR IR, laser gain material and specialty crystals. Material used in
production regularly include Fused Silica, BK-7, Filter glass, Pyrex,
Zerodur, YAG, Vanadate, germanium and Zinc Selenide to name a few.
Our master opticians can produce one off prisms and corner cubes for
prototype, then create a cost effective production process that
compete with many offshore manufacturers in cost but our of higher
quality. This team boasts over 100 years of optical manufacturing
experience in the entire value stream from raw material supply
(including crystal growth) through to thin film coatings.
Manufacturing tolerances
Diameters accommodated from 0.5mm to 600mm
Request a quote
Diameter tolerances +/-0.01mm
today! Minimum thickness produced 0.03mm
Radius of curvature from 5mm to flat
Radius of curvature tolerance +/- 0.25%
Surface quality of 5-2 scratch dig
Flatness held to lamda/20
Parallelism to 2arc seconds
Centration to 0.01mm

2. Coating Witness
Samples/ Coupons
Salvo EO produces and stocks witness samples with
multiple material types. Coating Coupons or Witness
Samples are use for evaluation checks to verify coating
conformity. With our large selection of stocked
samples and no lead times Salvo EO is a great place to
find and order any witness samples you may need
without a delay. Same day
shipping!!!
Standard Tolerances
Request a quote
today! Surfaces Dimensions
<2 fringes Dia: +/- .005”(.125mm)
S-D 60-40 Thk: +/-.01” (.25mm)
C.A. 90% Parallel: < 5’

3. Laser Rods/Crystals
Salvo EO can supply gain material and specialty crystals
manufactured to requested specifications within rigorous tolerances.
Salvo EO will also upon request, will pre-screen laser gain components
to virtually eliminate material performance concerns at the point of
system integration. With multiple passive and active test beds the
product you receive is guaranteed to perform in accordance with your
system specifications. Salvo EO also has the ability to refurbish laser
rods and slabs that have been chipped and/or have coating burns can
be re-polished and re-coated to original manufacturer’s specifications.
Laser Materials and Non-Linear Materials
Request a quote Nd:Yag, Er:Yag, CTH:Yag, Yb:Yag, Nd:YVO4,
today! Nd:YLF, KTP, KTA
-Parallelism held to 5 arc seconds -Flatness 1/20wave
-Perpendicularity held to 2 arc minutes -Pyramidal 1 arc minute
-Scratch Dig 3/2 -Angle tolerance held to 3 arc minutes
-Radius held to +/-.5%