1. Page 1 of 5
Normally,when the computer changed,we need to adjust 3 items:
1) Main boom
2) Main boom angle
3) Weight
Enter into adjusting screen
When in main page, press [ ] enter the code ” (2345 ”) then
press: [ENT] to enter into adjusting menu:
User Commissioning Instructions
2. Page 2 of 5
To push the bottom to enter the adjustment screen.
Main boom length and angle procedure
(1)Enter in the length adjust screen
User Commissioning Instructions
3. User Commissioning Instructions
Page 3 of 5
(2)make the boom all in, and keep it horizontal.
(3)“BoomA/D”70-90 ,[F2];to look at the “boom A/D”,
should be between 70-90, press F2 to length zero.
(4)to enter into angle adjust screen
(5)press F2 angle zero
(6)to derrick the main boom to max angle
(7) Press F4 angle full
(8) enter into boom length screen( current angle
adjusting screen press [ESC] ,
return to adjust main menu, find the length adjusting screen)
4. Page4 of 5
(9) Boom all out
(10)Press “F4” length full.( to look at “boom A/D”can not be over 1023.)
length and angle finished.
Weight adjusting
(1)Adjustment”; Press “3 Aux.” to enter into “Aux. Weight
Adjustment” screen
(2)Main boom extended to 14m, lift at least 10T weight,
lift the weights to angle between “55°-75°”
( the screen will show “UP”)
(3) Press [ENT], the cursor will flash on the “P”,
press[+][-] to change the data to meet the weight on the
screen meet the actual weight. Then press [F4] to save.
User Commissioning Instructions
5. Page5 of 5
(4)from 70°to down the boom smoothly, “DOWN” will be shown
on the screen, then [ENT],(should stop derricking), cursor
will flash on “P”, Press [+][-] to change the actual weight
“AW” to meet the weight. Then Press [F4] to save.
End of the adjusting the weight.
User Commissioning Instructions