Wireless fuel level sensors with Bluetooth and GSM. Technoton webinar on 06.04.2020

BLEGSM
“Advanced machinery telematics”
Series of express-webinars.
April 2020
ADVANCED MACHINERY TELEMATICS
Topic 3. Fuel level sensors with Bluetooth and GSM

2
“Advanced machinery telematics”. Series of express-webinars.
Diﬀerences in Technoton fuel level sensors
Classic
capacitive sensor
Diﬀerential sensor,
with 3rd electrode
2-in-1 sensor and tracker
in a single device
Wireless sensor
with Bluetooth
GSM
BLE
GSM56 %

3
Common fatures of all Technoton fuel level sensors
Signal ﬁltration (averaging function)
Bottom stop and screen ﬁlter
1000 мм 50 мм
Shortening and extending length
Temperature, ˚C
30 40 50 60 70
Fuellevel,mm
300
310
320
330
Temperature correction

4
DUT-E GSM в баке
GPS
Пользователь
GSM
Fuel level sensor and GPS tracker in one device.
Tank fuel volume measurement, geolocation and route tracking.
Data transfer to a telematics server, or directly via SMS and by e-mail.
in 12
GSM

5
• Creating and customizing Reports sent by the sensor to email, SMS and a server;
• Reduced volume of data sent to a server and faster operation of a server.
IoT Byrger Technology allows maximum data process “on board” of the sensor.
The Technology provides the following features:
• Detection of “Fuel drain” and “Tank reﬁll” Events;
• Self-diagnostics and saving data to Events Journal;
• Signal correction (ﬁltration, temperature correction, storing calibration table);
GSM
DUT-E GSM fuel level sensor
Data processing using IoT Burger Technology

6
Detecting Events, sending Reports
Standard: refiling/draining fuel, low/high onboard network voltage,
lost/established connection with satellites, engine start/stop. Configurable:
fuel level is lower than х%, exceeding allowed time of continuos vehicle
operation, speeding, etc.
Events
DUT-E GSM can send up to 20 different Reports simultaneously, on regular
basis or upon Event recognition.
Combination of 10 selected operation parameters. Reported is sent regularly
or triggered by Event, which is selected from the list.
Reports
GSM

7
Configuring Reports
“Reports Generator” menu in
DUT-E GSM service software allows
to create and configure up to 20
different Reports.
Reports can be configured remotely.
GSM

8
Sending data over email and SMS
Prompt notiﬁcation by SMS on recognized important Events.
Sending Reports to user’s e-mail without using telematics server.
GSM

9
Diagnostics and conﬁguration over the Internet
Remote check of sensor’s quality of operation - accuracy, settings, malfunctions.
Allows to conﬁgure sensor remotely without any physical connection.
GSM
InternetDiagnostics menu
...........ok
...........ok

10
Using S6 Technology, DUT-E GSM can receive data from:
1. Up to 15 DUT-E CAN or DUT-E 2Bio fuel level sensors.
2. Up to 16 DFM CAN or DFM Marine fuel ﬂow meters.
3. FSMCrocodile contactless FMS-gateway.
4. MasterCAN DAC J1939 i/o module for processing signals
of analog sensors, e.g. GNOM axle load sensors or third-party units.
Connecting other Technoton sensors and meters
Solution for
complex
objects
GSM

11
DFM CAN
EDC ECAEDC ECAEDC ECAS ABSS ABSS ABS
MasterCAN
CANCrocodile
CAN
K-Line
GNOM DDE
DUT-E GSM
DUT-E GSM in vehicle telematics system
DUT-E GSM is connected with other units using S6 Technology, receives data
from the devices and transfers aggregated information to telematics server.
GSM
No
external
tracker

12
Fuel tank Diesel generator
DUT-E GSM for stationary tanks and machines
DUT-E GSM
DFM CAN
GSM

13
GSM
Case/ Road building machinery
After DUT-E GSM installation customer can control the route and
location of vehicles.
Data on fuel (remaining fuel in tank, filling and draining) is always
available.
Manipulation with fuel and misuse of vehicles had stopped, 20%
fuel economy.
300 L
200 L
100 L
Discharge 30 L Refilling130 L
Change of the
fuel volume in tank
Route and location
monitoring

14
Summary
GSM
a 1. Two-in-one.
Saving time for installation and configuration. “Hardware/firmware incompatibility” is
not topical anymore.
a 2. Flexible Report generation system.
Receiving ready-for-use Reports, no need of further data processing
and creating report templates on teleamtics server.
a 3. Remote diagnostics and configuration over the Internet.
Saves customer’s time and efforts of technical support team.
a 4. Operation via CAN/S6.
Advanced telematics system connected over a single cable.
Compatibility is guaranteed, saves time on equipment installation and cabling.

16
Measuring “head” with PCB and
battery inside
Bottom stop (spring) and
screen ﬁlter
Measuring tubes (probe)
DUT-E S7 wireless fuel level sensor
Design

17
Sensitivity to fuel level change 0.1 mm
Wireless data transfer standard Bluetooth 4.X (BLE)
Range of signal transfer on a vehicle/in open area 20/40 m
Number of simultaneous signal receivers Unlimited
Data transfer interval 5 s
Length extension possibility Up to 6000 mm
Built-in battery life cycle at least 5 years
Main speciﬁcations

18
DFM S7
DUT-E S7
GNOMGNOM
DDEDDE S7
GSM 2G/3G
Telematics
service
Smartphone
Tracker
S7 Technology

19
Advantages of DUT-E S7
ь No device pairing procedure required.
ь Battery lifetime - 5 years.
ь No cable – no wire damage possible, increased resistance to vandalism.
ь No external power supply – ﬁre- and explosion- safety of the sensor.
ь ”BLE-radio” operation mode – signal is transmitted automatically to all Receivers in the range.
ь No cable – quick and simple installation of telematics equipment and its conﬁguration.

20
DUT-E S7 for vehicle telematics systems
Tracker
GSM 2G/3G
Telematics
service
Driver
Maintenance technician
or
ﬂeet inspector
GSM 15:45 57%
PARAMETERS
Fuel level ........... 45,7 mm
Fuel volume ............ 375 L
Fuel temperature ... 27 °C

21
Terminal
unit
+
2G/ 3G/ NB-IoT/ WiFi
Internet
SMS
e-mail
DUT-E S7 for stationary tanks and machines
Event – storage #4
3
Fill-up 30.00 m 29.04.2018, 15:44
Event – storage #3
3
Drain 0.22 m 26.04.2018, 13:22
Storage 1
0
10
20
30
40
50
Fuel
volume
3
34.833 m
Storage 2
0
10
20
30
40
50
Fuel
volume
3
7.653 m
Storage 3
0
10
20
30
40
50
Fuel
volume
3
44.768 m
Telematics
service

22
Fire- and explosion-safety
DUT-E S7 fuel level sensors are certiﬁed for explosion safety requirements.

23
Full list and configuration manuals can be found at www.j-technoton.com.
New devices are added.
Compatibility with tracking devices

24
“Fuel tank monitor” smartphone app
Creating configuration profiles for sensors.
Exporting and copying profiles.
Making fuel tank calibration table.
Data logging.
Diagnostics of sensor's malfunctions.
џ “Discharging”,
Configuring detection of Events:
џ “Fueling”,
џ “Low fuel level”.

25
Fuel monitoring ar driver’s service
"Discharging" alert is a "night watchman" feature helping driver
quickly react to a fuel theft at parking lot.
"Fuelling" Event helps driver to check volume of fuel received
at a gas station and compare it to cash receipt.

26
a”BLE-radio” opeartion mode used by DUT-E S7 excludes risk of disconnection from signal
receiver - data transfer occurs without interruption, all the time.
aNo signal and power cable needed means quicker and easier installation of DUT-E S7
and excludes a risk of intensional or occasional cable damage.
aDUT-E S7 is certified fire- and explosion-proof level sensor, which can be used for sta-
tionary tanks and does not require external spark protection devices.
a“Fuel tank monitor” smartphone app provides driver with a possibility of live data checking –
e.g. when refilling at gas station or when having a night rest at a parking lot (theft alerts).
Summary

Wireless fuel level sensors with Bluetooth and GSM. Technoton webinar on 06.04.2020

Recommended

Recommended

More Related Content

What's hot

What's hot (20)

Similar to Wireless fuel level sensors with Bluetooth and GSM. Technoton webinar on 06.04.2020

Similar to Wireless fuel level sensors with Bluetooth and GSM. Technoton webinar on 06.04.2020 (20)

More from Technoton

More from Technoton (20)

Recently uploaded

Recently uploaded (20)

Wireless fuel level sensors with Bluetooth and GSM. Technoton webinar on 06.04.2020