Wan configuration in packet tracer

1. Made by : Tanjilur Rahman
WAN: It means Wide-Area Network. When many other LAN or other
networks works together, then it called a WAN.
Now, we will try to making a simple WAN in packet tracer.
At first, we open the cisco packet tracer and select the Laptops and pcs and 2
Multilayer stitches and 2 routers. Then, we connect them properly with
following the figures...
1.

2. 2.
3.

3. 4.
Now, we configure the pcs and select an IP No. for switches.
5.

4. 6.
After All configurations, we configure the routers by following the figures.
7.
Note: Port status must be on…

5. 8.
This is important thing that, after configuration the pcs, select a router
and select the RIP and add the IP addresses under the router one by
one.
9.

6. 10.
11.
Here, we select a message and send it Laptop0 to pc0.

7. 12.
By opening the command form and pinging a message from Laptop3 to
pc2…
There is 0% loss.
So, we confirm that, Configuration of the WAN in Packet
tracer is success.