This document discusses configuring a smart home simulation in Cisco Packet Tracer, including connecting a home gateway, ceiling fan, window, fire sprinkler, siren, and smoke detector. Instructions are provided on configuring each device like the ceiling fan and window, connecting the home gateway for wireless access, and using a smart phone to control and monitor all connected devices.

1. Here, we try to configure a smart home in cisco packet tracer.
For this, at first, we will open the cisco packet tracer. And then select the
Home Gateway, Smart Phone, Ceiling fan, window, And for garage we select
the fire sprinkler, siren, smock detector etc…

2. And then, we follow the instruction that shown in bellow in the figures for
ceiling fan config…
Here, we configuration the window following the picture bellow…

3. In this figure, we try to configuration the home gateway with wireless config…
…
For making the home gateway more valuable we should use the Smart Phone-
PT and configure with home gateway… For This we can follow the instruction
bellow…

4. …
…
…
…
Here, we set the temperature of thermostat…
…
…

5. …
…
And here is smoke detector…
…
…

6. …
…
…
We can see all the devices in smart phone IoT Monitor…
…
…
…
…

7. From here, we can add or edit those devices…
…
…
…
…

8. The Window is Opened by smart phone…
From Here, We Can Control All Over The devices…