Smart Gloves project for Specially-abled people

1. RITESH KHANDARE –22104A2002
SHUBHANG MEHTA-21104A0004
SHIVAM PARSEKAR – 22104A2004
AKANSHA JADHAV – 21104A0023
GUIDED BY Dr. ANAND TRIPATHI
&
Prof. PRATIK MHATRE

2. INDEX
Introduction
Objective
Block Diagram
Hardware Requirements
Software Requirements
Cost Analysis
Results
References
2

3. Smart gloves using Arduino Uno and Flex sensors are a type of wearable
technology that can detect the bending of fingers and convert that
movement into a digital signal.
The gloves are typically made from flexible and breathable materials,
and the flex sensors are placed along the fingers and palm of the glove
The Arduino Uno is a popular microcontroller board that can be
programmed to read the sensor data and perform various functions
based on that data.
With the help of the flex sensors, the Arduino Uno can detect the hand
movements and translate them into different actions.
3
INTRODUCTION

4. Smart gloves can be used to
interpret sign language and
translate it into spoken or
written language, allowing
people with hearing
impairments to
communicate more easily.
Overall, the objective of
smart gloves using Arduino
Uno is to provide a new level
of interaction between
humans and technology,
making it more intuitive,
natural, and efficient.
4
OBJECTIVES

5. 5
•SMART
GLOVE
FLEX SENSOR
• HC05 BLUETOOTH
MODEL
• TP4056 Type –C
• 18650 BATTERY
ARDUINO
UNO
OUTPUT
BLOCK DIAGRAM

6. 6
ARDUINO UNO Type C charging module FLEX SENSOR
BATTERY HC-05 Bluetooth module
HARDWARE REQUIREMENTS

7. The Arduino IDE is an open-source software used to
provide instructions to micro controller.
It provides an environment where you can write
code and upload it to your micro controller.
It is available for Windows, Linux and MAC
operating system based computers
7
SOFTWARE REQUIREMENTS
ARDUINO IDE

8. COST ANALYSIS
Sr.
No.
Components Cost
1 ARDUINO UNO 700
2 HC 05 BLUETOOTH MODULE 250
3 FLEX SENSOR 350
4 18650 BATTERY 300
5 TP4056 TYPE C CHARGING MODULE 200
TOTAL 2000
8

9. RESULTS
9
*EARLY STAGE DEVELPOMENT OF THE PROJECT ON A BREADBOARD TO CHECK THE COMPONENTS AND INITIALIZE THE CODE*

10. REFERENCES
• arduino.cc/hardware/uno-rev3
• G. Saggio, “A novel array of flex sensors for a goniometric glove,”
Sensors Actuators: A Physical, vol.205, pp.119– 125, 2014
10

11. 11
THANK
YOU