Module question for module 10 - Aviation legislation , prepared with refrence to july exam session 2017 , may be helpful for November session 2017......
2. Q1- CAT.C Experience Requirement for Large A/C- (July session 2k17)
(A)- 3 yrs. Experience requirement exercising Cat.B1.1 or B1.3
or B2 privileges .
(B)- CAR 145 B1.1 , B1.3 or B2 support staff.
(C) – Both A & B
Q2- Documents to be carried on board is in accordance with (JULY 2017).
which rule –
(A) – Rule 7 of A/C rules 1937.
(B) - Rule 7A
(C) – Rule 25A
Q3 – The proposed revision in MEL shall be submitted to respective Airworthiness Office
for approval within ____________ after receipt of MMEL revision.
(A) - 12 days.
(B) - 30 days.
(C) - 31 days.
3. Q4- CAMO is applicable for –
(A) – CAR M subpart F organization .
(B)- CAR 145 Org.
(C) – Subpart F balloon only – 2730 kgs.
(D) – ATA.
Q5 - Post holder of Subpart G of CAR M has a comprehensive knowledge of which of the following
Manuel -
(A) – MOE.
(B) – MOM.
(C.) – Operational Manuel .
4. Q6 – Who will prepare a Flight Test Report –
(A) – P.I.C
(B) – Flight Crew
(C) – Maintenance Manager
(D) – Both A & B
Q7 - A copy of the airworthiness review certificate issued is sent to the DGCA
within ___________ of the date of issue.
(A) – 10 days.
(B) – 30 days.
(c) – 7 days.
5. Q8 – Approved Pilot Means – (Rev 6 27/10/2017 Series B part 1 , refer pg- 5 note in series B part 1)
(A) – Pilot Who is trained and Authorized By the Quality Control Manager of CAR 145 org.
(B) - AS in (A) + under the provision of CAR 145.A.30(j)(4) .
(C) – NOTA
Q9 – Why Flight Test is done –
(A) – To check Handling Characteristics .
(B) – To check Flight Characteristics.
(C) – To check correct Functioning of Equipment .
(D) – ATA.
6. Q10 – Continued Validity for AME license is for – (JULY 2017)
(A) – 4 yrs.
(B) – 5 yrs.
(C) – 3 yrs.
Q11 – Credits are granted in accordance with –
(A) – CAR section 2 series L part X.
(B) - CAR section 2 series E part VIII.
(C) – APM chapter 17.
Q12 – CAR M subpart I is related to –
(A) – ARC.
(B) – Certificate of Release to Service.
(C) – Maintenance Org.
7. Q13 – MTCS about CAT. B3 License Holder –
(A) – B3 is for Non-pressurized Piston – engine aero planes of MTOM 2000
kgs and below.
(B) – According to CAR 66 only 17B, 9B , 7B and 11C modules are
applicable for CAT.B3 .
(C) – Both (A) & (B) is correct .
Q14 – Small Organization means –
(A) – Less than 10 persons in Maintenance staff.
(B) – Org. with only 10 persons.
(C) – NOTA.
8. Q15 - The names of the certifying staff authorised to perform airworthiness
reviews will be written in –
(A) – Manual .
(B) – Exposition .
(C) – Either (A) or (B).
Q16 – who will sign a statement that the prepared MTOE is in compliance with CAR-147?
(A) – Maintenance Manager .
(B) – Quality Manager.
(C) – Chief Instructor .
(D) – Accountable Manager.
9. Q17 – If any Examiner found for providing Question and answer to students appearing in
knowledge examination should be disqualified from acting as examiner and the occurrence of any
such incident should be informed to DGCA within _________.
(A) – 31 days from the day of incident .
(B) – one Calendar month.
(C) – 1 year .
Q18 – It is whose responsibility to ensure that the Maintenance data provided by the
customer is current –
(A) – QM.
(B) – CAMO.
(C) – AM.
10. Q19 – Segregation means –
(A) – Storing Unsalvageable components .
(B) – storing Unserviceable components .
(C) – As in(B) + to be stored in a separate secured location from serviceable
components .
Q20 – Who will have a direct access to CEO(Chief executive officer) of the org.
(Feb – session 2017).
(A) – Accountable Manager.
(B) – QCM.
(C) – CAM.
11. Q21 – Credits expire ________ after they were granted to the applicant by DGCA.
(JULY 2017)
(A) – 5 yrs.
(B) – 6 yrs.
(C) – 10 yrs.
Q22 – For FTS continuation training is provided for a period of every ________- (JULY 2017)
(A) – 4 yrs.
(B) – 24 months
(C) – 2 yrs.
(D) – Either (B) or (C).
12. Q23 – The document which describes Design Organization Approval is –
(JULY 2017).
(A) – CAR 145.
(B) – CAR M.
(C) – CAR 21.
Q24 – MTCS (CA form 1)-
(A) – It is Authorized release certificate .
(B) – When org. maintains a component for use by the same org. then CA
Form 1 may not be necessary.
(C) – ATA.
13. Q25 – In case of small org. , the Contracted quality monitoring org. shall make –
(A) – 3 visit in 12 months.
(B) – 2 visits in 12 months.
(C) – 2 visits in 24 months.
Q26 – Application for initial issue of CAR 66 AME license is in accordance with
CA form _________ ? (july 2017).
(A) – 19-01.
(B) – 19-02.
(C) – 19-03.
14. Q27 – Maintenance of an aircraft is done according to – (july 2017)
(A) – Aircraft Maintenance program .
(B) – Maintenance Data.
(C) – DDPG ( Dispatch And Deviation Procedure Guide).
Q28 – The safety Policy should be signed by Whom – (july 2017)
(A) – Service Provider .
(B) – Accountable Executive .
(C) – QM.
Q29 – The safety policy should include the responsibilities of _________ with respect
to safety performance of the SMS. (july 2017)
(A) – Employee .
(B) – Operator.
(C) – Management and Employees .
15. Q30 – Minimum Age requirement of Certifying And support staff is –
(A) – 16 yrs.
(B) – 21 yrs.
(C) – 18 yrs.
16. So , this was a question bank of Module 10 it was prepared according to july session 2017 ……
The next question bank of module 10 and 9 – Human factors will be uploaded soon ….
Note – Correct options are highlighted.
For more study material and updates Stay tuned ……
THANK YOU SO MUCH FOR YOUR SUPPORT.
-CNAM737
LIKE , SUBSCRIBE , COMMENT and SHARE if u like it …………