Grade 8 Handicrafts

2. WHAT ARE THE PRINCIPLES OF
DESIGN?

3. WHAT ARE THE PRINCIPLES OF
DESIGN?
*HARMONY *PROPORTION
*BALANCE *RHYTHM
*EMPHASIS

4. *HARMONY -
RELATIONSHIP OF
THE DIFFERENT
PORTIONS OF THE
DESIGN.
-LAW OF UNITY
WITH VARIETY

5. *BALANCE -
RELATIVE SIZE AND
SCALE OF
OBJECTS.

6. *PROPORTION -
RELATIVE SIZE AND
SCALE OF
OBJECTS.

7. TRANSFER
RING
DESIGNS
QUARTER 1 HANDICRAFTS
WEEK 4

8. HOT-IRON
TRANSFER

9. HOT-IRON
TRANSFER
1.JREMOVE EXCESS PAPER
AROUND THE DESIGN.

10. HOT-IRON
TRANSFE
R
2.

11. HOT-IRON
TRANSFER

12. HOT-IRON
TRANSFER

13. HOT-IRON
TRANSFER

14. TRACING
METHOD

15. TRACIN
G
METHO
D
• DESIGNS MAY ALSO BE TRANSFERRED
USING A TRACING WHEEL AND
PREFERABLY DRESSMAKER’S CARBON
PAPER.
• WHEN NO CARBON PAPER OF THIS TYPE
IS AVAILABLE, ORDINARY CARBON
PAPER MAY BE USED.
• REMEMBER TO USE LIGHT-COLORED
CARBON PAPER IF YOUR FABRIC IS OF A
LIGHT COLOR.

16. TRACIN
G
METHO
D
1. PLACE YOUR DESIGN RIGHT SIDE
UP ON YOUR FABRIC THEN PIN AT THE
CORNERS. SLOWLY INSERT THE
CARBON PAPER OR DRESSMAKER’S
CARBON SIDE DOWN, BETWEEN THE
DESIGN AND FABRIC

17. TRACIN
G
METHO
D
2. USING A TRACING
WHEEL, GO OVER THE
LINES OF THE DESIGN.

18. TRACIN
G
METHO
D
3. YOU MAY ALSO USE A
PENCIL OR ANY SHARP
OR POINTED
INSTRUMENT TO TRACE
THE DESIGN.

19. TRACING
METHOD

20. STAMPIN
G

21. STAMPIN
G
YOU WILL NEED SOFT
ABSORBENT CLOTH,
INDIGO, KEROSENE OR
PETROLEUM, SHEETS
OF NEWSPAPER, YOUR
PERFORATED DESIGN,

22. STAMPIN
G
1. FORM THE SOFT
ABSORBENT CLOTH
INTO BALL.

23. STAMPIN
G
2. PREPARE
THE
BLUING

24. STAMPIN
G
3. SPREAD SHEET
OF NEWSPAPER
ON A FLAT
SURFACE. LAY
THE FABRIC ON
THE NEWSPAPER.

25. STAMPIN
G
4. LAY THE
PERFORATED
PATTERN SMOOTH
SIDE UP ON THE
PART OF THE FABRIC
WHERE THE DESIGN

26. STAMPIN
G
5. PIN THE
CORNERS
OF THE
DESIGN.

27. STAMPIN
G
6. DIP THE BALL OF
CLOTH IN BLUING
MIXTURE. RUB THE
BALL OF CLOTH OVER
THE DESIGN IN ONE
STOKE OR

28. STAMPIN
G
7. LIFT ONE CORNER
OF THE PATTERN
CAREFULLY TO
CHECK IF THE
DESIGN HAD BEEN
CORRECTLY

29. STAMPIN
G
8. WHEN THE
DESIGN HAS BEEN
FULLY
TRANSFERRED,
REMOVE THE
PERFORATED

30. STAMPIN
G

31. GOOD WORKING
HABIT
TO ENSURE CLEANLINESS AND MAINTAIN THE
GOOD QUALITY OF YOUR WORK, ALWAYS
BEAR IN MIND THE FOLLOWING GOOD
WORKING HABITS.