Scs – A World Of Possibilities R NewPresentation Transcript
SCS – A world of possibilities
SCS SYSTEM The Evolution of Building Technology
Unique pre-engineered custom-made lost-in-place formwork system consisting of Modular Wall Formwork Panels.
Components of SCS System
Fiber Cement Board
Light Gauge Galvanized Steel Studs
FORM-A-WALL is a permanent form work comprising of galvanized steel stud framing and fiber cement board, that serves as a finish wall surface. When filled with concrete forms a monolithic structural bearing wall and shear wall. Typical Section Custom made sizes can be arrangement to suit any design requirements. Components 112162 Thickness Height (mm) Width (mm) 2440,2745,2850,4050 min 153 to 1220 max Standard Sizes
BEAM FORMS COLUMN FORMS FORM-A-WALL BEAM AND COLUMN FORMS - Whenever required, beams and columns forms can be Pre-manufactured to any size to suit design requirements. Components
THERMA-WALL - 6” Thk wall with insulation on External side. Used for extreme temperatures regions. Components INSULATION INTERNAL SIDE FIBER CEMENT BOARD EXTERNAL SIDE
Form-a-wall Panel is then slide into starter bars and rest vertically on the bottom track after
which, check for plumpness and provide diagonal bracing to hold the panel temporarily.
- Screw panel on the bottom tracks.
Installation: Metal bracing
Completed ground floor wall panels with optional metal door and window jambs.
Upon completion of panel
installation, electrical and sanitary
rough-ins that goes into the wall
should be in placed before
Additional horizontal reinforcements
are placed inside the panel at an
interval of 340mm on centers.
(As per code requirements)
Pouring of concrete are done in
intervals of 300mm per layer with
Slump ratio equivalent to 7.
No Chipping required for conduit and utility boxes inside
Conduits are slide into the panel before pouring
concrete. Cut appropriate opening for utility box.
- Placing of electrical conduit into the wall. Integration with other services: Electrical Conduits PVC CONDUIT
Same procedure with electrical conduits, pipes are slid into the panels and cut appropriate holes for connection to bathroom fixture. Integration with other services: Plumbing Lines PVC PIPE FAUCET
ROOF TRUSS TO WALL DETAIL
Roof truss are anchored on the wall by welding anchor bar into the embedded angle bar on top of the panel.
Installation: 1”ANGLE BARS METAL TRUSS WALL PANEL X X XXX J-BARS
Recessed panel edges assures
Apply initial coat of jointing compound on the recessed edge, then attach the mess tape and
set dry before putting a final coat .
- Level excess jointing compound using fine grain sandpaper.