gsp 215 week 7 homework networking commands new,gsp 215 week 7 ilabnetworking and a tiny web server new,gsp 215 week 7 homework new,gsp 215 week 7 ilab new,gsp 215 lab7 report new,uop gsp 215,uop gsp 215 new,uop gsp 215 week 7 tutorial,gsp 215 week 7 assignment,uop gsp 215 week 7 help

1. DEVRY GSP 215 Week 7 Homework Networking Commands
NEW
Check this A+ tutorial guideline at
http://www.uopassignments.com/gsp-215-devry/gsp-
215-week-7-homework-networking-commands-recent
For more classes visit
http://www.uopassignments.com
Week 7 Homework—Networking Commands
This week's homework will focus on basic networking
commands.
Display IP configuration settings.
1. Open a Windows CLI (Start->run type in cmd and
press enter)
2. The ipconfig command is used to view a computer's
IP address. When your system is resolving the DNS
addresses incorrectly, flushing the DNS using ipconfig –
flushdns is a helpful command. To release and renew an
IP address, use ipconfig – release and ipconfig –renew.

2. What does subnet mask mean? What does default
gateway mean?
3. Ping is used to verify connectivity to a network.
Ping a web address of your choice, and press control + c
to stop it.
Paste the screenshot below.
4. Run traceroute on a website address of your choice
(control + c to stop). Example:
tracert devry.edu
5. Nslookup is helpful to know if the DNS is working
correctly. Run nslookup against a hostname to see if the
name is resolved. Example: nslookupwww.cnn.com
6. The netstat command has many options and gives a
lot of information about your network. The –a option
will show you the open ports on your computer.

3. 7. If you have a Windows machine, go to the control
panel on your computer. Then pick network and sharing
center.
Under view your active networks, you will see a link
next to connections (in the above picture it is wired).
Click on the link you see next to connections, then click
on properties. Select Internet protocol version 4
(TCP/IPv4), and click properties.
Note that changing these settings may disconnect you,
so click cancel rather than OK.
• To obtain IP settings automatically, click obtain an IP
address automatically, and then click OK.
• To specify an IP address, click use the following IP
address, and then in the IP address, subnet mask, and
default gateway boxes, type the IP address settings.
Take a screenshot of your settings.
Why would you choose