1. Salford City College
Eccles Sixth Form Centre
BTec Level 3
Extended Diploma in Creative Media Production
Games Design
Unit 66 – 3D Modelling
HA5 – Sidekick Task 6 – Production
Name Thomas Mcdonagh
10/3/14
Today I did scheduled for my assiagnment
Date: 11/3/14
Today I made a mood board of robots. While doing was trying to get different robots which have different purposes which I think I did do successfully because I
had a robot from real steel whose purpose is to box and c3-po from star wars who runs away from fights

2. Date: 11/3/14
Today I printed of the ideas generation sheet and the plan sheet for your robot. I then did the ideas generation until I felt I had enough ideas. I then went on to
do the plan for my robot. I had printed the sheet twice so that I could do a plan for the front and back.
Date: 20/3/14
Today I made a mood board of robots. While doingi was trying to get different robots which have different purposes which I think I did do successfully because I

3. had a robot from real steel whos purpose is to box and c3-#po from star wars who runs away from fights
Date: 31/3.14
1st I made a square using the box tab in the create mode. I then bevelled the square so that I could make it look better when I make the arm. I then used the
mirror tool to do the same on the other side of the box. I then used multishift to make the arms. I then made a edge on the so that the gun would look better. I
then did the same on the other side. Then used bevel to make the stand for the drinks tray

4. Date:22/4/14
I used bevel at the top of my box and make a head. I then used the size tool to make the head smaller I then used the tool to add colour using the Q key to the
robot. I then realised I had messed up earlier because when I was trying to add colour to the middle box it wouldn’t add all the colour. The problem I realised
was that somehow I had repeated making the box twice. And went back a few steps to correct my mistake. I the started to re add colour When I added a lot of
colour I decided I wanted to use different colours. Finally I used the knife tool to separate the bottom of the box show that I can give it legs. I then used the size
tool to extend the legs.

5. Date:1/5/14
I then added more colour to the robot. I then realised that the legs were together and it didn’t look good.

9. Date:28/4/14
Today I used layout to take screen shots of pictures I took when they were rendered. The tools in the software uses the same controls as modler. Apart from you
press enter to take a picture. While taking pictures you were supposed to get a 360 degrees look at your object in the pictures. I also added some skins to it to
make the robot look better