The document provides information on electrode maintenance for the PeriFlux 6000 tcpO2 device. It discusses the need to remembrane electrodes weekly or when exposed to infection to remove built-up silver oxide. The remembraning procedure involves removing the old membrane and O-rings, cleaning the electrode face, adding electrolyte solution, and inserting the electrode into a new membrane and O-rings. Electrodes can be cleaned with specified water-based disinfectants and should be stored capped with contact liquid when not in use.

1. Electrode Maintenance
PeriFlux 6000 | tcpO2 made intelligent

2. Disclaimer
The information contained in this document is intended to provide general
information only. It is not intended to be, nor does it constitute, medical advice.
Under no circumstances is the information contained in this document to be
interpreted as a recommendation for a particular treatment for specific
individuals. In all cases it is recommended that clinicians perform their own
interpretations of data in conjunction with the clinical assessment of their patient.
Due to Perimed’s commitment to continuous improvement of our products, all
specifications are subject to change without notice.
All information and content in this document is protected by copyright. All rights
are reserved. Users are prohibited from modifying, copying, distributing,
transmitting, displaying, publishing, selling, licensing, creating derivative works,
or using any information available in or through the document for commercial or
public purposes. All responsibility for any liability, loss or risk, personal or
otherwise, which is incurred as a consequence, directly or indirectly, of the use
and application of any of the material in this document is specifically disclaimed.

3. • Calibration
• tcpO2 Site Selection
• Electrode Maintenance
• Interpreting Curves and Results

4. Remembraning
• Electrodes build up a layer of silver oxide during use that
must be removed
• Remembrane electrodes weekly or when they come into
contact with any sort of infectious disease (e.g. MRSA)
• Calibrate twice after remembraning
• Remembraning is performed with the supplied kit

5. Remembraning Procedure
Use O-ring removal tool Remove both O-rings Remove membrane
Clean electrode face Clean circular groove Two drops of electrolyte
solution – NO bubbles!

6. Remembraning Procedure
Insert electrode into
cartridge and compress
New membrane and
two O-rings loaded

7. Electrode Care
• Electrodes can be cleaned with the following
water-based disinfectants:
– Hi-Tor Plus (Ecolab Inc.)
– MadaCide-FD (MADA Inc.)
– Control III (Maril Products Inc.)
• Never immerse plug in liquid
• Avoid exposing lead to alcohol-based
products (e.g. hand lotion, disinfectant)
• When electrodes are not in use, store with
cap on and two drops of contact liquid

8. Thank You!
PeriFlux 6000 | tcpO2 made intelligent
www.perimed-instruments.com