This document provides a quick guide for setting up field labels on a Zebra ZT410 300 DPI printer. The guide outlines 6 steps for configuring settings like darkness, velocity, roll pressure, sensor position, label roll position, and ribbon installation through the Zebra Designer software and manually on the printer.

1. Quick Guide to Setup Field Labels
Quick Guide to Setup Field Labels
Printer type: Zebra ZT410 de 300 DPI

2. Label type: Field labels (191 x 25 mm, each label)

3. Step Details Image
1. Darkness to print
Assign value with software Zebra Designer.
Go to menu FILE --> PRINTER SETTINGS and
assign the value 25

4. 2. Velocity to print
Assign value with software Zebra Designer.
Go to FILE --> PRINTER SETTINGS and assign
the value of 2

5. 3.
Pressure of rolls in the
head printer
Assign manually in the printer, calibrate to 3
4.
Position of red-light
sensor in the printer
Configure manually in the printer, see red arrows in
the image

7. 5.
Setting roll label and
hasp of labels
Configure manually in the printer, see red arrows in
the image where is indicating the red-lightmustgo out
through the round holes.

9. 6. Setting the ribbon