1. The document provides instructions for making a woven bracelet using jump rings of different sizes, pliers, and a clasp. 2. The instructions explain how to open and close rings, attach rings to create a basic chain, and add a "captured ring" between links to create a woven pattern. 3. The pattern is repeated, adding two small rings, two large rings, and one captured ring, until the bracelet reaches the desired length.

1. Materials:
2 x pairs of pliers - chain nose or flat nose
1 x clasp of your choice
Jump Rings
0.8mm(20g) 5mm ID (Inner Diameter)
0.8mm(20g) 3mm ID
1. Open some small and large rings. Also close some large
rings
Place four closed rings on a small ring then close.
Then add another small ring and close
2. Next separate the four large rings in half and place a
small ring through two of the large rings.
3. Now add another two closed large rings and then close
the small ring. Then add another small ring through the
same four large rings
You should now have a 2in2 chain like the one here.
4. Now for the tricky part. Time to add the captured ring,
the gold ring in the pictures.
You need to get a large open ring. Viewing the rings from
the side you want the ring to go in between the large rings
and around the outside of the small rings.
1

2. 5. To the next link add another captured ring
6. This is what you should now have. The weave should
appear quite flat. If not you have probably caught part of a
ring. Undo captured ring and try again.
7. As with step 3 you are now adding two small and two
large rings.
Now add a captured ring.
8. This pattern of two small, two large and one capture is
continued until you have your bracelet at the length you
want.
The finished bracelet. I love two tone and
below are some other ideas for you.
Another ring size I like is 1.2mm(16g) 4.5
& 7mm ID but as long as the small ring can
pass completely through the large ring it
will generally work for helm.
Please do not distribute, lend or copy
Copyright 2010 Shona’s Designs
2