This document provides instructions for making a homemade dog collar using paracord or thin rope. It lists the necessary materials which include paracord, a buckle, jump ring or D-ring, lighter, scissors and tape measure. It describes measuring the dog's neck to determine how much cord is needed and cutting the cord into strands. The instructions then detail how to thread the cord through the buckle and weave it into a collar, stopping where a jump ring can be added to attach tags before finishing the weaving.

2. What you will
need:

3. 1.Paracord or thin rope
2.Buckle
3.Jump ring or D-ring
4.Lighter
5.Scissors
6.Tape measurer/ruler

4. Measure your dogs current
collar or simply measure
around their neck

5. For every inch of collar you need one
foot of rope. So for my dogs 12 inch
collar, I will need to measure and cut
two strands of 12 foot string

6. If your using
paracord, burn
the ends of the
cord to prevent
fraying

10. 1. Take a strand of your cord and fold it together, making sure the ends are even.
Put the folded side into the female part of your buckle and take the ends of the
cord and pull it through (do this to the other piece of cord/rope also).
2. Separate your middle strands from your outer strands.
3. Start with one of your OUTER strands and go over the MIDDLE strands and
UNDER the other OUTER strand.
4.Pull the string through the loop you have just made.
5.Pull tight.
6.Pull tight.
7.Repeat
8.Repeat
9.Repeat
10. DO NOT weave all the bracelet yet, stop where you would like to add your
jump ring and your dog’s tags.

11. Add your jump ring
with your dogs tag
attached and simply
continue your
weaving process.