3. PA1 Primer is a single component air drying primer for
application to concrete and Portland cement based screeds.
PA1
PA1 Primer is used to seal the surface of concrete screeds
and to improve the adhesion of membranes, screeds and
coatings
4.
5.
6. ELIMINATOR Membrane is a two component spray-
applied system that forms a heavy duty, durable and
continuous joint free waterproofing membrane
ELIMINATOR Membrane protects
concrete and steel structures from the
corrosive effects of water and chloride
ions
7. Bond Coat 3 is a reactive, heat activated bond coat which is
solvent free.
Bond Coat 3 is formulated to provide superior
adhesion between ELIMINATOR Membrane
and a wide range of asphalt surfacing mix
designs
8. Tack Coat SA1030 is a polymer-modified bond coat
Tack Coat SA1030 is applied to the ELIMINATOR®
waterproofing membrane to provide a bond
between the membrane and the bituminous road
surfacing.
9. Wet Film Thickness testing
during application
Wet Film Thickness Gauges are
used to quickly and easily
measure the thickness of coatings
immediately after they have been
applied to a substrate.
10. Integrity Testing For
Waterproofing Membranes
High Voltage Testing:
The high voltage testing utilizes a
charged metal broom above the
membrane to create the electrical
potential difference.
11. Adhesion testing
Adhesion testing is a destructive
test most commonly applied on
exposed areas Ensuring the bond
of a waterproofing membrane to a
substrate .
