This document provides installation instructions for Window Control Covers for Tesla Model S and Model X vehicles. It begins with a disclaimer that the manufacturer is not responsible for any vehicle damage during installation or use of the product. It then lists the quick start installation steps, which include removing adhesive covers, adding extra adhesive strips to some pieces, positioning the covers and pressing them into place. It notes that the covers are intended for permanent installation but can be removed by prying, though the adhesive will be weakened and may not re-adhere properly.

1. EVannex® — Tesla Aftermarket Accessories
3413 SW 14
th
Street •• Deerfield Beach, FL 33442 •• www.evannex.com
Disclaimer: Evannex is not responsible for any vehicle damage caused during the installation or use of this product.
Any costs associated with any vehicle damage are the sole reponsibility of the purchaser.
Window Control Covers for Model S and Model X
Installation Instructions
Thanks for purchasing Window Control CoversTM
. Please read these installation instructions in their
entirety BEFORE you attempt to install the spoiler.
Window Control CoversTM
(WCC) has been designed to improve the interior aesthetic of your Model S
and Model X doors. We’ve created an Installation Video that can be viewed at evannex.com. We
strongly recommend that you view it BEFORE you install Glove Box BumperTM
.
Quick Start Installation Steps:
Tools suggested: Xacto blade (recommended, but not required).
Step 1. For the large driver side Window Control
CoversTM
(WCC), remove the red covering from the
double-sided tape on the bottom. Warning: The
tape is VERY sticky. DO NOT place it face down on
any surface before installation.
Step 2. Remove two strips of extra adhesive (dark
red color) from the tab provided and place the strip
over the existing adhesive on the large driver side
front and rear bottom surfaces. Note that we
provideyou with four (4) strips of tape. Keep the
two extras in case you need them later.
Step 3. Position the the large driver side WCC using the cutout for the circular mirror control as a
guide, slide in and check for positioning. Once you’re satisfied, press down hard on the front, back,
and side.
Step 4. Each of the smaller WCCs for the passenger side
front door and the rear doors are installed in an identical
manner. Remove the red adhesive tape covering,
position in place, check alignment, and press down hard.
There is no need to use any extra adhesive tape for these
pieces.
Your side Window Control CoversTM
(WCC) is now ready for
use.
Removal: Window Control CoversTM
(WCC), is intended
for permanent installation. To remove WCC, use a plastic
pry tool at either the front or rear and pry upward. It loosen and can then be pulled off from either the
right or left edge. IMPORTANT: Once removed, the adhesive will be weakened and will not adhere
properly if you re-install. Therefore, remove only if you do not intend to reuse this product.