The document provides instructions for basic procedures when using an image display device. It instructs the user to check that the image is displayed correctly on the screen. It then describes pushing various function keys to access settings for adjusting the positional and laser parameters, including changing the laser power setting to 30. The summary is provided in 3 sentences.

1. CHAPTER 6 BASIC PROCEDURES
Check and see Push IMAGE out of function keys and check to
Image see the
Indication. image screen for correct display.
LASER MARKER << IMAGE DISPLAY >> SUNX
ＦＩＬＥ：００２ [ＴＥＳＴＤＡＴＡ２ ]
HELP
Ｙ
ｘ 1.00 OPERATOR
Ｘ
Indicate
FILE
CHARACTER
Ａ Ｂ Ｃ Ｄ
Positional adjustment SET FUNC
東 京 都 Adjusted Chara( 1～30) CONDITION
X Position
-10.00 [mm]
SET LASER
Y Position
0.00 [mm]
SET TRIG
IMAGE
FLOPPY
MARKING MODE
ＳＴＡＲＴ ＳＴＯＰ INDICATE ENVIRON
RUN TEST
Push SET LASER Push SET LASER out of function keys.
out of function
keys
LASER MARKER << LASER SETTING >> SUNX
and change ＦＩＬＥ：００２ [ＴＥＳＴＤＡＴＡ２ ] HELP
various
setting for Laser power･･････ 20.0 Marking quality OPERATOR
laser
radiati Scanning speed･･･ 1000 [mm/S] Start･･ 100 Edge･･･ 100
FILE
Laser pulse cycle 50.0 [μ s] Stop･･･ 100 Curve･･ 100
on Line width･･･････ 0.06 [mm]
CHARACTER
SET FUNC
Marking pitch････ 0.03 [mm] Laser
power
CONDITION
100.0
SET LASER
TIME MEAS
SET TRIG
IMAGE
FLOPPY
MARKING MODE
ＳＴＡＲＴ ＳＴＯＰ INDICATE ENVIRON
RUN TEST
Set the laser Push Numerals for the laser power and have ten keys
power indicated
to 30. and then push numerals and symbols in the order
of 3 0
SETTING
Laser power

2. ３０
７ ８ ９ ← →
４ ５ ６ DEL
BS
１ ２ ３ CANCEL
０ ． － SETTING
6-9