This document provides instructions for setting marking conditions on a laser marker. It describes how to access the marking condition setting screen by pushing the CONDITION function key. It then lists and describes the various setting options that can be configured like character height, width, position, interval, font, laser power, scanning speed, and pulse cycle. It provides an example of how to set the X position to -10 by pushing numbers and symbols in the specified order.
1. .00 [mm]
.00 [mm]
CHAPTER 6 BASIC PROCEDURES
Push CONDITION
of function keys.
Push CONDITION to change the screen to the
marking
condition setting screen.
LASER MARKER
<< MARKING CONDITION >> SUNX
FILE:002 [TESTDATA2 ] HELP
GENERAL CHARACTER CAD OPERATOR
Condition number
Character height・
Character width・・
X Position・・・・・・・
1
5.00 [mm]
5.00 [mm]
0.00 [mm]
Set line・・・・・・・・・ 1 ~ 30
Marking shape Straight line
Font・・・・ Original 3
FILE
CHARACTER
SET FUNC
Y Position・・・・・・・
Char. interval・・・
Line interval・・・・
MARKING MODE
0
5
5.00 [mm]
Bold・・・・・・・・・・・・
Laser power・・・・・・
Scanning speed・・・
Laser pluse cycle
COPY
0.00 [mm]
100 [%]
100 [%]
100 [%]
PASTE
CONDITION
SET LASER
SET TRIG
IMAGE
FLOPPY
RUN TEST START STOP INDICATE ENVIRON
Set the marking
position to X=
-10.
Push Numerals for marking position and have ten
keys
Indicated and then push symbols and numerals in the
order of
- 1 0 SETTING
X position [mm]
-10
7 8 9 ← →
4 5 6 DEL BS
1 2 3 CANCEL
0 . - SETTING
LASER MARKER << MARKING CONDITION >> SUNX
FILE:002 [TESTDATA2 ] HELP
GENERAL CHARACTER CAD OPERATOR
Condition number
Character height・
Character width・・
1
5.00 [mm]
5.00 [mm]
Set line・・・・・・・・・ 1 ~ 30
Marking shape Straight line
FILE
CHARACTER
X Position・・・・・・・ -10.00 [mm] Font・・・・ Original 3 SET FUNC
Y Position・・・・・・・
Char. interval・・・
Line interval・・・・
MARKIN
0.00 [mm]
5.00 [mm]
5.00 [mm]
Bold・・・・・・・
・・・・・
Laser
power・・・・・・
Scanning
speed・・・
Laser pluse cycle
COPY
2. 0.00 [mm]
100 [%]
100 [%]
100
[%]
PASTE
CONDITION
SET LASER
SET TRIG
IMAGE
FLOPPY
RUN TEST START STOP INDICATE ENVIRON
6-8