1. CHAPTER 6 BASIC PROCEDURES
6-1 Method of booting system
Connectio Proceed the connections for booting this system by
referring
n
to “Chapter 4 Connections” and by confirming its
contents. CAUTION Laser pumping or marking
cannot be started
unless the connections to Terminal base
1.2.3.4.10.11.12.13 are done.
Refer to External Control Manual
"Chapter 3
Control from terminal block and I/O
connectors"
for the details of the connections.
TO CONSOLE
The connection method varies slightly
from
configuration to configuration (The
REFERENCE
connection shown in the figure above is
for the case where
a console is used). Observe
instructions given in “Chapter 5
Installation”.
MAIN SWITCH ON Turn on the Main switch on the rear of the
controller.
→ The main power source indicator is lit green.
6-1