1) The document describes basic procedures for using a laser marker, including how to select a test and push test to display a small black circle within a larger circle. 2) It explains that pushing start will begin the marking process. 3) Users are cautioned that test marking cannot be suspended by pushing stop.
http://www.cnc.info.pl//files/fanuc_ot_cnc_program_manual_gcodetraining_588.pdf
Found this programming training manual at the link above, fairly decent, worth a look.
http://www.cnc.info.pl//files/fanuc_ot_cnc_program_manual_gcodetraining_588.pdf
Found this programming training manual at the link above, fairly decent, worth a look.
1. CHAPTER 6 BASIC PROCEDURES
Select Test Push Test to have small black circle appeared in large
circle
marking
( ).
LASER MARKER << IMAGE DISPLAY >> SUNX
F I L E:0 0 2 [T E S T D A T A 2 ]
HELP
Y
x 1.00 OPERATOR
X
Indicate
FILE
CHARACTER
A B C D SET FUNC
Positional adjustment
Adjusted Chara( 1~ 30) CONDITION
東 京 都
X Position
-10.00 [mm]
SET LASER
Y Position
0.00 [mm]
SET TRIG
IMAGE
FLOPPY
MARKING MODE
ST AR T STOP INDICATE ENVIRON
RUN TEST
Push START Push START . Marking starts.
CAUTION Test marking cannot be susupended by STOP