This checklist outlines the startup procedure for a Boeing 757-200 aircraft. It involves turning on electrical systems like batteries, generators, and buses. It also includes initializing hydraulic, fuel, bleed air, anti-ice, and engine systems. Specific steps include starting the APU, turning on pumps and valves, programming the flight computer, and using the engine ignition to sequentially start each engine to reach the proper RPM levels before releasing parking brakes for taxi.

1. Boeing 757 – 200 Start Up Checklist<br />ELECTRICAL PANEL – LIGHTS PANEL<br />BATTERY SWITCH: ON – STANDBY CTR: AUTO – NAV LIGHTS: ON<br />APU GEN: ON – BUS TIE L/R: ON – UTILITY BUS: ON – L/R GEN CONT: ON<br />APU SWITCH: START – Please wait for a steady APU RUN LIGHT it can take several minutes<br />HYDRUALIC PANEL – WINDOW HEAT<br />YAW DAMPER L/R: ON IRS: ALIGN THEN NAV – WINDOW HEAT: ON<br />ENG PUMPS L/R: ON – ELECTRICAL PUMPS: OFF<br />BLEED CONTROL PANEL<br />ENG BLEED VALVES L/R: ON – APU BLEED: ON – ISOLATION VALVE: ON<br />PACK CONTROL: AUTO – TRIM AIR: ON – RECIRC FANS: ON<br />Program the Flight Manager Computer FMC<br />HYDRAULIC – FUEL CONTROL PANEL – LIGHTS PANEL<br />Pressurize electrical right system first<br />ELECTRIC PUMPS RIGHT: ON – ELECTRIC PUMPS CENTER ½: ON<br />ELECTRIC PUMPS LEFT: ON – ANTI COLISION BEACON LIGHTS: ON<br />CROSSFEED: OFF – RIGHT FUEL PUMPS AFT/FWD: ON<br />If the right centre tank contains fuel: ON<br />ENGINE CONTROL PANEL – BLEED PANEL – ANTIE ICE<br />PACK CONTROL SELECTORS; OFF – ANTI ICE; OFF<br />ENGINE IGNITION SWITCH: 2 ENG START SELECTORS; GND<br />Monitor your EICAS display for stable levels<br />Thrust idle – parking brake set<br />CUTOFF FUEL SWITCHES<br />ENG FUEL CUTOFF 2: PUSH<br />Wait until reach about 20 – 23% N2, and push the cut off lever. After success and stabilized percentage, repeat the procedure for engine 1, by setting left fuel switches ON, switching Eng. Ignition to 1 and finally Eng Start Selectors to GND Position.<br />BLEED – ANTI ICE – APU PANEL<br />L/R ENG BLEED VALVES: OFF – APU: OFF – ISOLATION VALVE: OFF<br />PACK CONTROL SECLECTOR: AUTO – ANTI ICE: AS REQUIRD APU SWITCH: OFF<br />FLIGHT DECK<br />TRIM: T/O POSITION – FLAPS: SET FOR T/O<br />AUTO BRAKES: RTO – FLIGHT DIRECTIR: ON<br />