1. ~Check the size of dowels & mark for drilling hole~ Thursday 21/04/11<br />02794000-114300127000Today I checked if the size of dowels is same. It was same size. So next plane was to mark out the where should I drill the hole. Emotion- I tried to marking for drill the hole, but it was really difficult to mark on the base. First time, I was marking like this picture. Using the ruler and measure 20mm each and mark with pencil, but I checked if the length between 2 mark points is same. It was not same, so I have to mark again. I had no idea to mark exactly position. I asked Mr. Anderson to how can I mark exact position. And this is how did I fix it. I used the compass to mark correct position. Compass is so useful and important for this project for me. <br />Next<br />Next class, I will mark Pig’s back for drill the hole. I only finished Pig’s face for drill the hole, and I haven’t finish marking. I have 2 periods for DT, so I can finish marking for about 15 minutes. After mark Pig’s back, I will drill the hole. I am going to use pedestal drill for drill the hole. Make sure I have to check if a drill pit is fit as my dowels size. I really have to care that I am not going to drill hole through the pig’s back and face. <br />AOI-Environments<br /> Today I had two dowels rest that I am not going to use for my project. I was going to dump the dowels, but someone wanted to use that dowels, so I gave it. Also I have a dowel left, so I just put in the Grade 8 box, because maybe I will use that dowel for this project, and other people will use it. It’s good for environment, because I didn’t waste wood.<br />